arm gpio setting
sneha prakash
sneghu at gmail.com
Thu May 13 05:42:38 EDT 2010
Hi ,
We are using i.mx 25 board which consists of arm9 controller.I need
to
convert the CMOS connector in the board to parallel port pins.We
have to
convert CMOS connector pins to GPIO pins using IOMUX
configuration.Could
any one help me to configure GPIO pins as parallel port pins and to
set
the base address.
Regards,
sneha.
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://lists.infradead.org/pipermail/linux-arm/attachments/20100513/9a732bb1/attachment.htm>
More information about the linux-arm
mailing list