ARM IOMUX GPIO SETTING
snehajp at collabera.com
Thu Aug 26 01:29:24 EDT 2010
We are using i.mx 25 board which consists of arm9 controller.I need to
convert the CMOS connector in the board to parallel port pins.We have to
convert CMOS connector pins to GPIO pins using IOMUX configuration.Could
any one help me to configure GPIO pins as parallel port pins and to set
the base address.
This e-mail contains Privileged and Confidential Information intended solely for the use of the addressee(s). It shall not attach any liability on the
sender or Collabera or its affiliates. Any views or opinions presented in this email are solely those of the sender and may not necessarily reflect the
opinions of Collabera or its affiliates. If you are not the intended recipient, you should not disseminate, distribute or copy this e-mail. Please notify
the sender immediately and destroy all copies of this message and any attachments.
WARNING: Computer viruses can be transmitted via email. While Collabera has taken reasonable precautions to minimize this risk, Collabera accepts no
liability for any damage that may be caused to you in the event that there is any virus in this e-mail or any attachments attached hereto. It is the
addresses(s) duty to check and scan this email and any attachments attached hereto for the presence of viruses prior to opening the email.
** Thank You **
More information about the linux-arm