[PATCH] interconnect: qcom: icc-rpmh: Add opt-out parameter for QoS settings

[Raviteja Laggyshetty]

On 9/8/2026 1:04 PM, Abel Vesa wrote:
> On 26-09-07 22:15:09, Marc Zyngier wrote:
>> On Mon, 07 Sep 2026 21:21:44 +0100,
>> Abel Vesa <abel.vesa at oss.qualcomm.com> wrote:
>>>
>>> On 26-09-07 18:17:29, Marc Zyngier wrote:
>>>> Recent addition of QoS configuration to the X1 variants resulted in
>>>> systems that spontaneously reset at boot time or under load.
>>>>
>>>> Given that this is both very unpleasant and hard to debug, give the
>>>> affected user the option to survive such event with a module parameter.
>>>>
>>>> Passing "icc_rpmh.enable_qos=0" to the kernel command-line will skip the
>>>> offending QoS setup.
>>>>
>>>
>>> Lets not start doing this, please.
>>>
>>> Can we figure out which platform deosn't work and then maybe we can 
>>> add a quirk in DT per platform?
>>
>> We have at least 3 machines that are dysfunctional since [1] was
>> merged (mini-x, sp12 and devkit). Probably some more, but I'm not
>> going to be the one doing a survey.
>>
>> What really should happen is [1] to be reversed until QC figures out a
>> set of parameters that actually works, instead of making this platform
>> even more unreliable than it already is.
> 
> I'd rather have the patch reverted than adding a module parameter which
> users might not know about and distros will probably never addopt.
> 
>>
>> Just like [2] should have been reverted.
>>
>> Until then, we'll have to paper over this stuff.
> 
> But a module parameter complicates things rather than just papering over.
> 
> I suggest we get both reverted if they break existing platforms.

I will share a patch to add interconnect support for Purwa. 
Purwa is similar to Hamoa, but there are few port additions and deletions with 
respect to PCIe, and trying to program QoS for them can result in crash. 

Thanks,
Raviteja.