[PATCH] clk: milbeaut: Return divider update timeouts

[Pengpeng Hou]

m10v_clk_divider_set_rate() logs when the hardware does not clear its
write-valid request, but still returns success to the clock framework. It
also uses the sleeping poll helper while holding the divider spinlock.

Use the atomic poll helper under the lock and return its timeout so the
rate change is not reported as successful before the hardware accepts it.

The issue was found by our static-analysis tool and manually reviewed.

Fixes: 6a6ba5b55a72 ("clock: milbeaut: Add Milbeaut M10V clock controller")
Assisted-by: gpt 5
Signed-off-by: Pengpeng Hou <hppiscas at 163.com>
---
 drivers/clk/clk-milbeaut.c | 10 ++++++----
 1 file changed, 6 insertions(+), 4 deletions(-)

diff --git a/drivers/clk/clk-milbeaut.c b/drivers/clk/clk-milbeaut.c
index 4265bc442dfd..b3bf569ef747 100644
--- a/drivers/clk/clk-milbeaut.c
+++ b/drivers/clk/clk-milbeaut.c
@@ -410,8 +410,8 @@ static int m10v_clk_divider_set_rate(struct clk_hw *hw, unsigned long rate,
 				unsigned long parent_rate)
 {
 	struct m10v_clk_divider *divider = to_m10v_div(hw);
-	int value;
 	unsigned long flags = 0;
+	int value, ret = 0;
 	u32 val;
 	u32 write_en = BIT(divider->width - 1);
 
@@ -433,8 +433,10 @@ static int m10v_clk_divider_set_rate(struct clk_hw *hw, unsigned long rate,
 
 	if (divider->write_valid_reg) {
 		writel(M10V_DCHREQ, divider->write_valid_reg);
-		if (readl_poll_timeout(divider->write_valid_reg, val,
-			!val, M10V_UPOLL_RATE, M10V_UTIMEOUT))
+		ret = readl_poll_timeout_atomic(divider->write_valid_reg, val,
+						!val, M10V_UPOLL_RATE,
+						M10V_UTIMEOUT);
+		if (ret)
 			pr_err("%s:%s couldn't stabilize\n",
 				__func__, clk_hw_get_name(hw));
 	}
@@ -444,7 +446,7 @@ static int m10v_clk_divider_set_rate(struct clk_hw *hw, unsigned long rate,
 	else
 		__release(divider->lock);
 
-	return 0;
+	return ret;
 }
 
 static const struct clk_ops m10v_clk_divider_ops = {
-- 
2.50.1 (Apple Git-155)