[PATCH net-next 0/9] net: stmmac: qcom-ethqos: add Shikra EMAC support

[Mohd Ayaan Anwar]

On Fri, Sep 04, 2026 at 12:13:42AM +0530, Mohd Ayaan Anwar wrote:
> This series incorporates feedback from the RFC and adds the dt-bindings
> and driver changes required to enable Gigabit Ethernet support on the
> Qualcomm Shikra SoC. DTS changes will be sent out separately.
> 
> The series has grown from the RFC and can be broadly divided into three
> areas: PHY power supply management, proper support for RGMII ID mode in
> the Qualcomm ETHQOS driver, and Shikra specific clock dependencies
> required for NOC access.
> 
> 1. Shikra EVK boards use a GPIO-gated regulator for the DP83867 PHY
> power supply. Patches 1 and 2 add supply management to the DP83867
> driver so the PHY driver holds the regulator vote at probe. These
> changes are largely inspired by similar work done for the QCA8081 PHY:
> https://lore.kernel.org/netdev/20260605010022.968612-3-elder@riscstar.com/
> 
> 2. The generic RGMII fixes from the RFC remain. As suggested, an
> additional patch now emits a warning (patch 6) when the legacy "rgmii"
> or "rgmii-txid" modes are detected. A new change (patch 7) now
> initialises the RGMII link clock at SPEED_10 on probe instead of
> SPEED_1000, dropping the unnecessary 250 MHz source before link up.
> 
> 3. NOC clock voting (patch 8) now uses dev_pm_opp_set_rate() so the
> required VDD_CX performance state can be propagated through the clock
> controller. The Shikra binding (patch 3) is updated accordingly: an
> if/else block constrains Shikra to exactly six clocks and requires
> operating-points-v2.
> 
> Testing:
> The following boards have been tested with this new (proper) handling
> for RGMII ID:
>   - Shikra CQ/IQ variants (with the TI DP83867 PHY)
>   - QCS615 Ride (with the Micrel KSZ9031 PHY)
>   - Talos EVK (again with the Micrel KSZ9031 PHY)
>   - Talos Lyra EVK (TI DP83867 PHY, this board also has a GPIO-gated
>     regulator for the PHY power supply)
> 
> Changes since RFC:
>   - Two new patches add supply management for the DP83867, replacing
>     the gpio-hog approach for PHY power -- Konrad, Andrew.
>   - Use dev_pm_opp_set_rate() for the NOC AXI clock and require
>     operating-points-v2 for Shikra -- Konrad.
>   - Warn on legacy "rgmii"/"rgmii-txid" to encourage DTB migration --
>     Andrew, Maxime.
>   - Updated binding document for qcom,ethqos and snps,dwmac.
>   - Drop the duplicate "axi" clock from Shikra's DT; use "axi-noc" and
>     "pcie-tile-axi-noc" as the only additional clock-names.
>   - Initialise RGMII link clock at SPEED_10 rather than SPEED_1000 on
>     probe.
>   - Link to RFC: https://lore.kernel.org/netdev/20260612-shikra_ethernet-v1-0-f0f4a1d19929@oss.qualcomm.com/
> 
> Signed-off-by: Mohd Ayaan Anwar <mohd.anwar at oss.qualcomm.com>

Sashiko raised some valid concerns, I will update the series and send
out v2 shortly.

	Ayaan