[PATCH 1/1] PM: runtime: change stub pm_runtime_get_if_active() return 1 when !CONFIG_PM

[Dan Carpenter]

On Fri, Oct 30, 2026 at 08:46:07AM -0500, Alex Elder wrote:
> On 10/30/26 3:57 AM, Sakari Ailus wrote:
> > Hi Frank,
> > 
> > Thanks for the patch.
> > 
> > On Thu, Oct 29, 2026 at 12:30:37PM -0400, Frank.Li at oss.nxp.com wrote:
> > > From: Frank Li <Frank.Li at nxp.com>
> > > 
> > > When CONFIG_PM is not enabled, all devices runtime PM state should be
> > > treated as active.
> > > 
> > > __pm_runtime_resume() returns 1 (called by pm_runtime_get()).
> > > pm_runtime_get_if_active() is the try-and-get version of pm_runtime_get().
> > > stub pm_runtime_active() also returns true. So pm_runtime_get_if_active()
> > > should return the same value as the stub pm_runtime_get(), which is 1.
> > 
> > Shouldn't the same change be done to pm_runtime_get_if_in_use()? It's
> > otherwise the same, except that it requires also the use count to be
> > non-zero.
> I think "yes."
> 
> I think the logic for !CONFIG_PM should basically pretend runtime
> PM is enabled for all devices, and they're all ACTIVE and effectively
> in use.
> 
> That implies:
> - disable_depth == 0, so usage accounting would (if enabled) be done
> - runtime_status == RPM_ACTIVE (power is on, no delay)
> - usage_count > 0
> - runtime_error == 0
> - Maybe ignore_children is false?
> 
> This might not be complete (and could be wrong!).
> 

We could add this kind of information as a comment somewhere?

regards,
dan carpenter