(subset) [PATCH 0/7] arm64: renesas: r8a78000: Enable GPIO support

[Bartosz Golaszewski]

On Fri, 23 Oct 2026 19:50:38 +0200, Geert Uytterhoeven wrote:
> 	Hi all,
> 
> This patch series enables GPIO support for the Renesas R-Car X5H SoC, as
> found on the Renesas Ironhide development board.  On this board, clocks,
> power-domains, and resets must be accessed only through SCMI firmware.
> 
> The series is a bit special, in that most patches are not meant to be
> applied upstream yet:
>   1. The first patch, targeting the GPIO tree, restores the abily to use
>      the R-Car GPIO driver on a system that does not have pin control
>      support yet (pin control is not yet supported by SCMI on Ironhide),
>   2. The second patch, targeting a shared DT bindings branch, adds GPIO
>      clock definitions,
>   3. The third patch, targeting renesas-devel, adds GPIO device nodes to
>      the R-Car X5H .dtsi file,
>   4. The remaining patches are marked RFC or DNI; the latter depend on
>      code or DTS that is not yet upstream.  More detail can be found in
>      the individual patches.
> 
> [...]

Applied, thanks!

[1/7] gpio: rcar: Convert to gpiochip_generic_{request,free}()
      https://git.kernel.org/brgl/c/5e826d71d4839d8471784d968274823f1f492eb5

Best regards,
-- 
Bartosz Golaszewski <bartosz.golaszewski at oss.qualcomm.com>