[PATCH v3] PCI: rockchip: Don't lengthen PERST# when power is already valid

[Shawn Lin]

在 2026/10/28 星期三 9:59, Enrique Hernández Bello 写道:
> On Wed, 28 Oct 2026 09:34:04 +0800, Shawn Lin wrote:
> 

...

> 
>> Furthermore, even with the same power supply design, different endpoints
>> may behave differently. What if a particular device requires a longer
>> reset pulse to work reliably? How would we handle that?
> 
> The only floor the spec gives is T_PERST, 100 us of active PERST#, and v4
> started guaranteeing that explicitly with an fsleep() rather than relying on
> the 100 ms. Beyond that there is no required minimum to preserve.
> 
> And the short pulse is not new behaviour: from the driver's introduction
> until c47f90be4c89 in v6.11-rc1 there was no wait before the de-assert at
> all, so the pulse was only as long as the register writes in between took.
> That is what every endpoint on this driver saw for years. The 100 ms pulse
> is the recent change, and it is what broke this one. If some device turns
> out to need longer, that seems like a quirk for that device rather than a
> reason to keep a default that regressed another.
> 

Was it possible to add a DT property for configurable delay? I came
across several EPs need quite a longer wait time, so add it in the
vendor tree for dwc-based IP[1]. That could be applied here to slove
your cases and others', and might avoid regression.

[1] 
https://github.com/rockchip-linux/kernel/blob/develop-6.12/drivers/pci/controller/dwc/pcie-dw-rockchip.c#L865