[PATCH V2 1/2] ARM: dts: imx6ull-dhcor-maveo-box: Remove unused SPI device

[Christoph Niedermaier]

On the maveo box, the SPI pins are connected to connector X10,
but no device is connected. The device "dhcom-board" was used
only to test the hardware, but was not removed afterward. So
remove this device to accurately represent the current hardware
configuration here. Also remove the okay status, since there
are no longer any devices defined in the interface.

Fixes: 145e2732a5e9 ("ARM: dts: imx6ull-dhcor: Add Marantec maveo box")
Signed-off-by: Christoph Niedermaier <cniedermaier at dh-electronics.com>
---
Cc: Rob Herring <robh at kernel.org>
Cc: Krzysztof Kozlowski <krzk+dt at kernel.org>
Cc: Conor Dooley <conor+dt at kernel.org>
Cc: Frank Li <Frank.Li at nxp.com>
Cc: Sascha Hauer <s.hauer at pengutronix.de>
Cc: Pengutronix Kernel Team <kernel at pengutronix.de>
Cc: Fabio Estevam <festevam at gmail.com>
Cc: Marek Vasut <marex at nabladev.com>
Cc: devicetree at vger.kernel.org
Cc: imx at lists.linux.dev
Cc: kernel at dh-electronics.com
Cc: linux-kernel at vger.kernel.org
---
V2: - Remove also okay status
---
 arch/arm/boot/dts/nxp/imx/imx6ull-dhcor-maveo-box.dts | 9 ---------
 1 file changed, 9 deletions(-)

diff --git a/arch/arm/boot/dts/nxp/imx/imx6ull-dhcor-maveo-box.dts b/arch/arm/boot/dts/nxp/imx/imx6ull-dhcor-maveo-box.dts
index 047f7b2d8526..0b48de79c595 100644
--- a/arch/arm/boot/dts/nxp/imx/imx6ull-dhcor-maveo-box.dts
+++ b/arch/arm/boot/dts/nxp/imx/imx6ull-dhcor-maveo-box.dts
@@ -59,15 +59,6 @@ &ecspi4 {
 	cs-gpios = <&gpio2 15 GPIO_ACTIVE_LOW>;
 	pinctrl-0 = <&pinctrl_ecspi4>;
 	pinctrl-names = "default";
-	status = "okay";
-
-	spidev at 0 {
-		compatible = "dh,dhcom-board";
-		reg = <0>;
-		spi-cpha;
-		spi-cpol;
-		spi-max-frequency = <54000000>;
-	};
 };
 
 &gpio1 {
-- 
2.30.2