[PATCH 4/4] cpufreq: add an Amlogic speed-bin driver

Christain Stefan Köver-Draxl ckoever at outlook.de
Mon Oct 26 03:10:12 PDT 2026


Hi Viresh,
Hi Jerome,

On 10/26/26 09:57, Jerome Brunet wrote:
> On lun. 26 oct. 2026 at 11:00, Viresh Kumar <viresh.kumar at linaro.org> wrote:
>
>> On 25-10-26, 20:22, christian.koever-draxl at student.uibk.ac.at wrote:
>>> From: Christian Stefan Kövér-Draxl <ckoever at outlook.de>
>>>
>>> Every S4 speed bin runs the same CPU frequencies but needs its own
>>> voltage curve, and the bin can only be read through the secure monitor.
>>>
>>> Read the bin from the firmware, select the matching
>>> "opp-microvolt-speed<bin>" property for all CPUs, then register
>>> cpufreq-dt. Bins outside the known range fall back to bin 0, which
>>> has the highest voltages. Like sun50i-cpufreq-nvmem, the driver binds
>>> on the SoC compatible and needs no node of its own, and S4 is added to
>>> the cpufreq-dt-platdev blocklist so cpufreq-dt is only created after
>>> the bin has been applied.
>>>
>>> Signed-off-by: Christian Stefan Kövér-Draxl <ckoever at outlook.de>
>>> ---
>>>   MAINTAINERS                          |   1 +
>>>   drivers/cpufreq/Kconfig.arm          |  14 ++
>>>   drivers/cpufreq/Makefile             |   1 +
>>>   drivers/cpufreq/amlogic-cpufreq.c    | 184 +++++++++++++++++++++++++++
>>>   drivers/cpufreq/cpufreq-dt-platdev.c |   2 +
>>>   5 files changed, 202 insertions(+)
>>>   create mode 100644 drivers/cpufreq/amlogic-cpufreq.c
>> Is it safe to apply just this one ? I can take this via the PM tree then.
> I would advise to wait a little for Amlogic to chime in.
>
> Patch 2 is something I already rejected back when S4 support was
> initially introduced. I suppose AI just unearthed it and did not bother
> to mention it.
>
> Amlogic was supposed to migrate to SCMI at that point, and possibly
> handle CPU frequency scaling through the secure fw entirely.
>
> They did on later SoCs, I don't know where their FW stands on the S4.

In my board's firmware there is no SCMI. CPU DVFS only works through the 
clock SMCs.

Best regards,
Christian

>
>> -- 
>> viresh



More information about the linux-arm-kernel mailing list