[PATCH 2/7] arm64: dts: qcom: shikra-iqs-evk: Add DLC0697 panel overlay

[Vishnu Saini]

Add a DT overlay for IQS, to enable DLC0697 panel when DLC daughter card
connected to PDISP1 DSI0 on carrier card.
Configure DLC0697 reset GPIO, supplies, pinctrl states and GPIO backlight
controlled through PM8150 GPIO 1.

Disable the default HDMI bridge and connector in favour of the DSI
panel.

Signed-off-by: Vishnu Saini <vishnu.saini at oss.qualcomm.com>
---
 arch/arm64/boot/dts/qcom/Makefile                  |  3 +
 .../boot/dts/qcom/shikra-iqs-evk-dlc-panel.dtso    | 78 ++++++++++++++++++++++
 2 files changed, 81 insertions(+)

diff --git a/arch/arm64/boot/dts/qcom/Makefile b/arch/arm64/boot/dts/qcom/Makefile
index c8907e77c893..0c5a7b7f694b 100644
--- a/arch/arm64/boot/dts/qcom/Makefile
+++ b/arch/arm64/boot/dts/qcom/Makefile
@@ -380,9 +380,12 @@ dtb-$(CONFIG_ARCH_QCOM)	+= shikra-iqs-evk-imx577-camera.dtb
 
 shikra-cqm-evk-hdmi-dtbs	:= shikra-cqm-evk.dtb shikra-cqm-cqs-evk-hdmi.dtbo
 shikra-cqs-evk-hdmi-dtbs	:= shikra-cqs-evk.dtb shikra-cqm-cqs-evk-hdmi.dtbo
+shikra-iqs-evk-dlc-panel-dtbs	:= shikra-iqs-evk.dtb shikra-iqs-evk-dlc-panel.dtbo
 
 dtb-$(CONFIG_ARCH_QCOM)	+= shikra-cqm-evk-hdmi.dtb
 dtb-$(CONFIG_ARCH_QCOM)	+= shikra-cqs-evk-hdmi.dtb
+dtb-$(CONFIG_ARCH_QCOM)	+= shikra-iqs-evk-dlc-panel.dtb
+
 dtb-$(CONFIG_ARCH_QCOM)	+= sm4250-oneplus-billie2.dtb
 dtb-$(CONFIG_ARCH_QCOM)	+= sm4450-qrd.dtb
 dtb-$(CONFIG_ARCH_QCOM)	+= sm6115-fxtec-pro1x.dtb
diff --git a/arch/arm64/boot/dts/qcom/shikra-iqs-evk-dlc-panel.dtso b/arch/arm64/boot/dts/qcom/shikra-iqs-evk-dlc-panel.dtso
new file mode 100644
index 000000000000..2542abe59d34
--- /dev/null
+++ b/arch/arm64/boot/dts/qcom/shikra-iqs-evk-dlc-panel.dtso
@@ -0,0 +1,78 @@
+// SPDX-License-Identifier: BSD-3-Clause
+/*
+ * Copyright (c) Qualcomm Technologies, Inc. and/or its subsidiaries.
+ */
+
+/dts-v1/;
+/plugin/;
+
+#include <dt-bindings/gpio/gpio.h>
+
+&{/} {
+	model = "Qualcomm Technologies, Inc. Shikra IQS EVK DLC Panel";
+
+	backlight: backlight {
+		compatible = "gpio-backlight";
+		gpios = <&pm8150_gpios 1 GPIO_ACTIVE_HIGH>;
+		default-on;
+	};
+};
+
+&hdmi_bridge {
+	status = "disabled";
+};
+
+&hdmi_connector {
+	status = "disabled";
+};
+
+&mdss_dsi0 {
+	#address-cells = <1>;
+	#size-cells = <0>;
+
+	panel at 0 {
+		compatible = "dlc,dlc0697", "ilitek,ili7807s";
+		reg = <0>;
+		backlight = <&backlight>;
+		reset-gpios = <&tlmm 3 GPIO_ACTIVE_LOW>;
+		vddi-supply = <&pm8150_l15>;
+		avdd-supply = <&vreg_disp_3p3>;
+		avee-supply = <&vreg_disp_3p3>;
+		pinctrl-0 = <&panel_rst_n &panel_te_pin>;
+		pinctrl-1 = <&panel_rst_n_suspend>;
+		pinctrl-names = "default", "sleep";
+
+		port {
+			panel_in: endpoint {
+				remote-endpoint = <&mdss_dsi0_out>;
+			};
+		};
+	};
+};
+
+&mdss_dsi0_out {
+	remote-endpoint = <&panel_in>;
+};
+
+&tlmm {
+	panel_rst_n: panel-rst-n-state {
+		pins = "gpio3";
+		function = "gpio";
+		drive-strength = <8>;
+		bias-disable;
+	};
+
+	panel_rst_n_suspend: panel-rst-n-suspend-state {
+		pins = "gpio3";
+		function = "gpio";
+		drive-strength = <2>;
+		bias-pull-down;
+	};
+
+	panel_te_pin: panel-te-pin-state {
+		pins = "gpio86";
+		function = "mdp_vsync_p";
+		drive-strength = <2>;
+		bias-pull-down;
+	};
+};

-- 
2.34.1