[PATCH 1/2] tty: serial: remove hub6 multiport support

[Hugo Villeneuve]

On Fri, 16 Oct 2026 19:12:19 +0200
"Arnd Bergmann" <arnd at arndb.de> wrote:

> On Fri, Oct 16, 2026, at 18:48, Hugo Villeneuve wrote:
> > On Fri, 16 Oct 2026 14:59:47 +0200
> 
> >> -			scnprintf(buf, size, " I/O:0x%lx, offset 0x%x", port->iobase, port->hub6);
> >> +		scnprintf(buf, size, " I/O:0x%lx", port->iobase);
> >>  	}
> >
> > With this simplification, you can now remove the {} braces...
> 
> Done
> 
> >> diff --git a/drivers/tty/serial/sunsu.c b/drivers/tty/serial/sunsu.c
> >> index 4ff3e5c41dab..f43b802add12 100644
> >> --- a/drivers/tty/serial/sunsu.c
> >> +++ b/drivers/tty/serial/sunsu.c
> >> @@ -106,10 +106,6 @@ static unsigned int serial_in(struct uart_sunsu_port *up, int offset)
> >>  	offset <<= up->port.regshift;
> >>  
> >>  	switch (up->port.iotype) {
> >> -	case UPIO_HUB6:
> >> -		outb(up->port.hub6 - 1 + offset, up->port.iobase);
> >> -		return inb(up->port.iobase + 1);
> >> -
> >>  	case UPIO_MEM:
> >>  		return readb(up->port.membase + offset);
> >
> > Maybe change to a simple if/else?
> >
> > 	if (up->port.iotype == UPIO_MEM)
> > 		return readb(up->port.membase + offset);
> > 	else
> > 		return inb(up->port.iobase + offset);
> >
> 
> I think I'd rather not change sunsu.c any more than necessary.

Ok


-- 
Hugo Villeneuve