[PATCH] platform/raspberrypi: vchiq: register bus at subsys_initcall

[Gaston Gonzalez]

On Tue Oct 13, 2026 at 10:14 AM -03, Martin Wetterwald wrote:
> Since the VCHIQ interface was moved out of staging, its bus is no longer
> guaranteed to be registered before its client drivers. bcm2835-audio,
> still in drivers/staging, registers at device_initcall level and now
> runs first:
>
>   Driver 'bcm2835-audio' was unable to register with bus_type
>   'vchiq-bus' because the bus was not initialized.
>
> Register the bus and the platform driver at subsys_initcall so the bus
> exists before any client driver, independently of link order. The
> platform driver probe already returns -EPROBE_DEFER while the firmware
> is not ready, so probing earlier is safe. When built as modules, this is
> equivalent to module_init() and nothing changes.
>
> Tested on Raspberry Pi 1B rev2, 1B+, 2B, 3B and 4B with VCHIQ and
> bcm2835-audio both builtin and both as modules.
>
> Fixes: aa125180c673 ("platform/raspberrypi: Destage VCHIQ interface")
> Reported-by: Martin Wetterwald <martin at wetterwald.eu>
> Link: https://lore.kernel.org/r/CAFERDQ0FpdVvA5VJxOyRAE_pgxnPVmFx1tkZio5R272j6Bs4tg@mail.gmail.com/
> Closes: https://lore.kernel.org/r/CAFERDQ0FpdVvA5VJxOyRAE_pgxnPVmFx1tkZio5R272j6Bs4tg@mail.gmail.com/
> Signed-off-by: Martin Wetterwald <martin at wetterwald.eu>
> ---
>  drivers/platform/raspberrypi/vchiq-interface/vchiq_arm.c | 2 +-
>  1 file changed, 1 insertion(+), 1 deletion(-)
>
> diff --git a/drivers/platform/raspberrypi/vchiq-interface/vchiq_arm.c b/drivers/platform/raspberrypi/vchiq-interface/vchiq_arm.c
> index e78641703252..d35f5ac5c2e2 100644
> --- a/drivers/platform/raspberrypi/vchiq-interface/vchiq_arm.c
> +++ b/drivers/platform/raspberrypi/vchiq-interface/vchiq_arm.c
> @@ -1462,7 +1462,7 @@ static int __init vchiq_driver_init(void)
>  
>  	return ret;
>  }
> -module_init(vchiq_driver_init);
> +subsys_initcall(vchiq_driver_init);
>  
>  static void __exit vchiq_driver_exit(void)
>  {

Hi,

For Raspberry Pi Zero v1.3:

Tested-by: Gaston Gonzalez <gascoar at gmail.com>

Test setup:

- Branch: patch manually applied in staging-next over commit ec1ecf4f23c5
- Setup: RPi Zero v1.3 connected to a HDMI monitor
- OS: standard raspbian with the desktop environment enabled
- Driver built both as a module and built-in.
- The following command was run to test the sound: 'speaker-test -t wav -c 2'
- Result: Both HDMI audio channels worked correctly

I’d be happy to run any additional tests if needed.

Regards,

Gaston