[PATCH v1 1/1] arm64: dts: imx8mm-var-dart-sonata: Add OV5640 camera support

[Stefano Radaelli]

From: Stefano Radaelli <stefano.r at variscite.com>

Add support for the OV5640 camera connected to the Sonata carrier
board's first MIPI CSI port.

Describe the sensor on I2C2, its 24 MHz reference clock, fixed supplies,
and reset and power-down signals controlled by the GPIO expander.
Connect the sensor to the MIPI CSI receiver using two data lanes and
enable the receiver and CSI bridge.

Signed-off-by: Stefano Radaelli <stefano.r at variscite.com>
---
 .../dts/freescale/imx8mm-var-dart-sonata.dts  | 66 +++++++++++++++++++
 1 file changed, 66 insertions(+)

diff --git a/arch/arm64/boot/dts/freescale/imx8mm-var-dart-sonata.dts b/arch/arm64/boot/dts/freescale/imx8mm-var-dart-sonata.dts
index 57d29a5c3821..427a255fe8ec 100644
--- a/arch/arm64/boot/dts/freescale/imx8mm-var-dart-sonata.dts
+++ b/arch/arm64/boot/dts/freescale/imx8mm-var-dart-sonata.dts
@@ -75,12 +75,39 @@ clk40m: oscillator {
 		clock-output-names = "can_osc";
 	};
 
+	camera_clk: oscillator-cam {
+		compatible = "fixed-clock";
+		#clock-cells = <0>;
+		clock-frequency = <24000000>;
+	};
+
 	pcie0_refclk: pcie0-refclk {
 		compatible = "fixed-clock";
 		#clock-cells = <0>;
 		clock-frequency = <100000000>;
 	};
 
+	reg_camera_1v5: regulator-camera-1v5 {
+		compatible = "regulator-fixed";
+		regulator-name = "CAM_1V5";
+		regulator-min-microvolt = <1500000>;
+		regulator-max-microvolt = <1500000>;
+	};
+
+	reg_camera_1v8: regulator-camera-1v8 {
+		compatible = "regulator-fixed";
+		regulator-name = "CAM_1V8";
+		regulator-min-microvolt = <1800000>;
+		regulator-max-microvolt = <1800000>;
+	};
+
+	reg_camera_2v8: regulator-camera-2v8 {
+		compatible = "regulator-fixed";
+		regulator-name = "CAM_2V8";
+		regulator-min-microvolt = <2800000>;
+		regulator-max-microvolt = <2800000>;
+	};
+
 	reg_usdhc2_vmmc: regulator-vmmc-usdhc2 {
 		compatible = "regulator-fixed";
 		pinctrl-names = "default";
@@ -95,6 +122,10 @@ reg_usdhc2_vmmc: regulator-vmmc-usdhc2 {
 	};
 };
 
+&csi {
+	status = "okay";
+};
+
 &ecspi1 {
 	pinctrl-names = "default";
 	pinctrl-0 = <&pinctrl_ecspi1>;
@@ -200,6 +231,26 @@ ft5x06_ts: touchscreen at 38 {
 		wakeup-source;
 	};
 
+	ov5640_mipi1: camera at 3c {
+		compatible = "ovti,ov5640";
+		reg = <0x3c>;
+		clocks = <&camera_clk>;
+		clock-names = "xclk";
+		AVDD-supply = <&reg_camera_2v8>;
+		DOVDD-supply = <&reg_camera_1v8>;
+		DVDD-supply = <&reg_camera_1v5>;
+		powerdown-gpios = <&pca6408_1 3 GPIO_ACTIVE_HIGH>;
+		reset-gpios = <&pca6408_1 1 GPIO_ACTIVE_LOW>;
+
+		port {
+			ov5640_mipi1_ep: endpoint {
+				remote-endpoint = <&mipi1_sensor_ep>;
+				clock-lanes = <0>;
+				data-lanes = <1 2>;
+			};
+		};
+	};
+
 	extcon_ptn5150: typec at 3d {
 		compatible = "nxp,ptn5150";
 		reg = <0x3d>;
@@ -263,6 +314,21 @@ st33ktpm2xi2c: tpm at 2e {
 	};
 };
 
+&mipi_csi {
+	status = "okay";
+
+	ports {
+		port at 0 {
+			reg = <0>;
+
+			mipi1_sensor_ep: endpoint {
+				remote-endpoint = <&ov5640_mipi1_ep>;
+				data-lanes = <1 2>;
+			};
+		};
+	};
+};
+
 &pcie_phy {
 	fsl,refclk-pad-mode = <IMX8_PCIE_REFCLK_PAD_INPUT>;
 	fsl,tx-deemph-gen1 = <0x2d>;
-- 
2.47.3