[PATCH v3 2/2] arm64: zynqmp: Add ifm ZynqMP VHIP6 EvalBoard

[Michal Simek]

On 9/16/26 22:44, Marek Vasut wrote:
> Add support for ifm ZynqMP VHIP6 EvalBoard reference design.
> The board is populated with four ethernet ports, QSPI NOR,
> eMMC, UART and USB host interfaces.
> 
> Signed-off-by: Marek Vasut <marex at nabladev.com>
> ---
> Cc: Conor Dooley <conor+dt at kernel.org>
> Cc: Krzysztof Kozlowski <krzk+dt at kernel.org>
> Cc: Michal Simek <michal.simek at amd.com>
> Cc: Rob Herring <robh at kernel.org>
> Cc: devicetree at vger.kernel.org
> Cc: linux-arm-kernel at lists.infradead.org
> Cc: linux-kernel at vger.kernel.org
> ---
> NOTE: Checkpatch complains about ethernet-phy-id2000.a240 being
>        undocumented, but the TI DP83822I is generic C45 PHY that
>        is valided by Documentation/devicetree/bindings/net/ethernet-phy.yaml
> ---
> V2: - Rename lm75 node to sensor@
>      - Use GPIO_ACTIVE_LOW macro
> V3: - Drop bogus clk_ignore_unused bootargs
>      - Drop gpio line names
> ---
>   arch/arm64/boot/dts/xilinx/Makefile           |   1 +
>   .../dts/xilinx/zynqmp-vhip6-evalboard.dts     | 300 ++++++++++++++++++
>   2 files changed, 301 insertions(+)
>   create mode 100644 arch/arm64/boot/dts/xilinx/zynqmp-vhip6-evalboard.dts
I am not able to review or take this board support further without publicly 
available hardware documentation for the platform (board-level and relevant 
interface details). Please share public documentation links once available, and 
I’ll be happy to revisit the patches.

Thanks,
Michal