[PATCH 4/4] ARM: dts: aspeed: add Intel JNCRP BMC

[Andrew Lunn]

> +&mdio1 {
> +	status = "okay";
> +
> +	ethphy1: ethernet-phy at 0 {
> +		compatible = "ethernet-phy-id001c.c916";
> +		reg = <0>;
> +		reset-gpios = <&gpio0 ASPEED_GPIO(C, 1) GPIO_ACTIVE_LOW>;
> +		reset-assert-us = <10000>;
> +		reset-deassert-us = <50000>;
> +	};
> +};
> +
> +&mac1 {
> +	status = "okay";
> +	pinctrl-names = "default";
> +	pinctrl-0 = <&pinctrl_rgmii2_default>;
> +	clocks = <&syscon ASPEED_CLK_GATE_MAC2CLK>,
> +		 <&syscon ASPEED_CLK_MAC2RCLK>;
> +	clock-names = "MACCLK", "RCLK";
> +	phy-mode = "rgmii-id";
> +	phy-handle = <&ethphy1>;
> +};

For these two nodes only:

Reviewed-by: Andrew Lunn <andrew at lunn.ch>

    Andrew