[PATCH 9/9] gpio: mxc: simplify gpio_set_wake_irq() with irq_set_irq_wake and assign_bit

[Andy Shevchenko]

On Sat, Oct 3, 2026 at 3:10 PM Peng Fan (OSS) <peng.fan at oss.nxp.com> wrote:
>
> To simplify gpio_set_wake_irq():
>  - Replace the enable/disable_irq_wake() if/else branches with a single
>    irq_set_irq_wake() call which handles both directions internally.
>  - Replace the separate set_bit()/clear_bit() calls with assign_bit()
>    which sets or clears the bit based on the enable parameter.

...

> -       if (enable) {
> -               if (port->irq_high && (gpio_idx >= 16))
> -                       ret = enable_irq_wake(port->irq_high);
> -               else
> -                       ret = enable_irq_wake(port->irq);
> -               if (!ret)
> -                       set_bit(gpio_idx, &port->wakeup_pads);
> -       } else {
> -               if (port->irq_high && (gpio_idx >= 16))
> -                       ret = disable_irq_wake(port->irq_high);
> -               else
> -                       ret = disable_irq_wake(port->irq);
> -               if (!ret)
> -                       clear_bit(gpio_idx, &port->wakeup_pads);
> -       }
> +       if (port->irq_high && (gpio_idx >= 16))
> +               ret = irq_set_irq_wake(port->irq_high, enable);
> +       else
> +               ret = irq_set_irq_wake(port->irq, enable);

> +       if (!ret)
> +               assign_bit(gpio_idx, &port->wakeup_pads, enable);
>
>         return ret;

This uses an unusual pattern, we check for the error first.
But also this part should not be ping-ponged over the series, it
should be from the start like this, see my comment against the
respective patch.

>  }

-- 
With Best Regards,
Andy Shevchenko