[PATCH 0/3] arm64: dts: freescale: Add Apalis iMX8 and Colibri iMX8X overlays

[Ernest Van Hoecke]

This series adds device tree overlays for the Toradex Apalis iMX8 and
Colibri iMX8X SoMs, and describes the Cortex-M4 remote processor on
Colibri iMX8X.

The series adds support for:
- NAU8822 Bridge Tied Load configuration on the Apalis Evaluation
  Board V1.2
- Cortex-M4 remote processor on Colibri iMX8X
- Reserving the Colibri iMX8X Cortex-M4 UART for firmware

The remote processor is described in the SoM device tree, following
the Verdin iMX8M Mini support. It uses the same entry address, mailbox
and RPMsg memory layout as the iMX8QXP MEK.

The Makefile entries build the standalone overlays as DTBOs and add
ready-to-use composed DTBs for the Apalis iMX8QM V1.1 on Evaluation
Board V1.2 and the Colibri iMX8QXP on Evaluation Board V3.

Signed-off-by: Ernest Van Hoecke <ernest.vanhoecke at toradex.com>
---
Ernest Van Hoecke (3):
      arm64: dts: freescale: imx8-apalis: Add NAU8822 Bridge Tied Load
      arm64: dts: freescale: imx8x-colibri: Add Cortex-M4 remoteproc support
      arm64: dts: freescale: imx8x-colibri: Add Cortex-M4 UART overlay

 arch/arm64/boot/dts/freescale/Makefile             | 11 +++++
 .../imx8-apalis-eval-v1.2-nau8822-btl.dtso         | 15 +++++++
 .../boot/dts/freescale/imx8x-colibri-uart-m4.dtso  | 18 +++++++++
 arch/arm64/boot/dts/freescale/imx8x-colibri.dtsi   | 47 ++++++++++++++++++++++
 4 files changed, 91 insertions(+)
---
base-commit: 39be5a7e3ecc08098c039561237499aa595700da
change-id: 20260930-v1-apalis-colibri-imx8-dtsos-632607d6275d

Best regards,
-- 
Ernest Van Hoecke <ernest.vanhoecke at toradex.com>