[PATCH 05/10] ARM: dts: imx6ulz: Fix BSH SMM-M2 WLAN host wake configuration

[Haoning Cheng]

From: Roman Smrž <roman at amarulasolutions.com>

The pin is active when high, so pull-up configuration can trigger
unwanted interrupts during module loading or unloading. Change the
configuration to pull-down to avoid crashes there.

Disable cap-sdio-irq as it is not used by the driver.

Signed-off-by: Roman Smrž <roman at amarulasolutions.com>
Signed-off-by: Haoning Cheng <Haoning.CHENG at cn.bosch.com>
---
 arch/arm/boot/dts/nxp/imx/imx6ulz-bsh-smm-m2.dts | 3 +--
 1 file changed, 1 insertion(+), 2 deletions(-)

diff --git a/arch/arm/boot/dts/nxp/imx/imx6ulz-bsh-smm-m2.dts b/arch/arm/boot/dts/nxp/imx/imx6ulz-bsh-smm-m2.dts
index 792d23a39390..362a26a2a1b1 100644
--- a/arch/arm/boot/dts/nxp/imx/imx6ulz-bsh-smm-m2.dts
+++ b/arch/arm/boot/dts/nxp/imx/imx6ulz-bsh-smm-m2.dts
@@ -85,7 +85,6 @@ &usdhc2 {
 	non-removable;
 	cap-power-off-card;
 	keep-power-in-suspend;
-	cap-sdio-irq;
 	mmc-pwrseq = <&usdhc2_pwrseq>;
 	status = "okay";
 
@@ -152,7 +151,7 @@ MX6UL_PAD_CSI_DATA02__USDHC2_DATA2	0x17059
 			MX6UL_PAD_CSI_DATA03__USDHC2_DATA3	0x17059
 			MX6UL_PAD_SD1_DATA3__GPIO2_IO21		0x3029		/* WL_REG_ON */
 			MX6UL_PAD_UART2_CTS_B__GPIO1_IO22	0x100b1		/* WL_DEV_WAKE - WiFi_GPIO_4 - WiFi FW UART */
-			MX6UL_PAD_UART1_CTS_B__GPIO1_IO18	0x1b0b1		/* WL_HOST_WAKE - WIFI_GPIO_0 - OOB IRQ */
+			MX6UL_PAD_UART1_CTS_B__GPIO1_IO18	0x130b1		/* WL_HOST_WAKE - WIFI_GPIO_0 - OOB IRQ */
 			MX6UL_PAD_ENET1_RX_EN__OSC32K_32K_OUT	0x4001b031	/* OSC 32Khz wifi clk in */
 		>;
 	};

-- 
2.43.0