[PATCH 4/4] ARM: dts: aspeed: x570d4u: Add some GPIO line names

[Renze Nicolai]

Several GPIO lines used on the board had no gpio-line-names entry.
Name the NMI button and control lines (GPIOA2/A3), the BIOS flash
chip-select and LPC reset outputs (GPIOJ1/J3), and the hard
power-off control line (GPIOAB3).

Signed-off-by: Renze Nicolai <renze at rnplus.nl>
---
 arch/arm/boot/dts/aspeed/aspeed-bmc-asrock-x570d4u.dts | 6 +++---
 1 file changed, 3 insertions(+), 3 deletions(-)

diff --git a/arch/arm/boot/dts/aspeed/aspeed-bmc-asrock-x570d4u.dts b/arch/arm/boot/dts/aspeed/aspeed-bmc-asrock-x570d4u.dts
index fca14320829e..0089845a6f0b 100644
--- a/arch/arm/boot/dts/aspeed/aspeed-bmc-asrock-x570d4u.dts
+++ b/arch/arm/boot/dts/aspeed/aspeed-bmc-asrock-x570d4u.dts
@@ -79,7 +79,7 @@ iio-hwmon {
 &gpio {
 	status = "okay";
 	gpio-line-names =
-	/*  A */ "input-locatorled-n", "", "", "", "", "", "", "",
+	/*  A */ "input-locatorled-n", "", "button-nmi-n", "control-nmi-n", "", "", "", "",
 	/*  B */ "input-bios-post-cmplt-n", "", "", "", "", "", "", "",
 	/*  C */ "", "", "", "", "", "", "control-locatorbutton-n", "",
 	/*  D */ "button-power-n", "control-power-n", "button-reset-n",
@@ -92,7 +92,7 @@ &gpio {
 	/*  H */ "", "", "", "", "input-mfg-mode-n", "",
 		 "led-heartbeat-n", "input-case-open-n",
 	/*  I */ "", "", "", "", "", "", "", "",
-	/*  J */ "output-bmc-ready-n", "", "", "", "", "", "", "",
+	/*  J */ "output-bmc-ready-n", "output-bios-cs-n", "", "output-lpc-reset", "", "", "", "",
 	/*  K */ "", "", "", "", "", "", "", "",
 	/*  L */ "", "", "", "", "", "", "", "",
 	/*  M */ "", "", "", "", "", "", "", "",
@@ -114,7 +114,7 @@ &gpio {
 		 "", "",
 	/* AA */ "input-cpu1-thermtrip-latch-n", "",
 		 "input-cpu1-prochot-n", "", "", "", "", "",
-	/* AB */ "", "input-power-good", "", "", "", "", "", "",
+	/* AB */ "", "input-power-good", "", "control-hard-power-off", "", "", "", "",
 	/* AC */ "", "", "", "", "", "", "", "";
 };
 
-- 
2.56.0