[PATCH v1 2/2] arm64: dts: freescale: imx95-aquila-clover: Keep DP_PWR always enabled

[Francesco Dolcini]

From: Francesco Dolcini <francesco.dolcini at toradex.com>

DP_PWR on the DisplayPort connector powers active DP cables and
adapters, which do not work without it. Keep it always enabled, and mark
it boot-on so that the firmware, e.g. U-Boot, enables it at boot,
whether or not a display driver is available.

Fixes: 3f519121e120 ("arm64: dts: freescale: imx95-aquila: Add Clover carrier board")
Signed-off-by: Francesco Dolcini <francesco.dolcini at toradex.com>
---
 arch/arm64/boot/dts/freescale/imx95-aquila-clover.dts | 2 ++
 1 file changed, 2 insertions(+)

diff --git a/arch/arm64/boot/dts/freescale/imx95-aquila-clover.dts b/arch/arm64/boot/dts/freescale/imx95-aquila-clover.dts
index 07bf53240958..37fa107c6fec 100644
--- a/arch/arm64/boot/dts/freescale/imx95-aquila-clover.dts
+++ b/arch/arm64/boot/dts/freescale/imx95-aquila-clover.dts
@@ -41,6 +41,8 @@ reg_dp_3p3v: regulator-dp-3p3v {
 		/* Aquila GPIO_21_DP */
 		gpios = <&gpio3 21 GPIO_ACTIVE_HIGH>;
 		enable-active-high;
+		regulator-always-on;
+		regulator-boot-on;
 		regulator-max-microvolt = <3300000>;
 		regulator-min-microvolt = <3300000>;
 		regulator-name = "DP_3V3";
-- 
2.47.3