[PATCH v2 0/3] Add ADLINK LEC-iMX95 board support

[Dinesh kumar v]

This patch series adds device tree support for the ADLINK LEC-iMX95
module on the I-Pi SMARC Plus carrier board.

The series includes:

 - Add the ADLINK vendor prefix to vendor-prefixes.yaml.

 - Add the ADLINK LEC-iMX95 compatible strings to the Freescale
   i.MX device tree binding.

 - Add the common device tree description for the LEC-iMX95 module.

 - Add the I-Pi SMARC Plus carrier board device tree.

The module device tree describes the onboard peripherals and interfaces,
while the carrier board device tree describes the carrier-specific
hardware connections.

The device tree has been compiled and validated using DT schema checks.

Changes in v2:

 - Add the ADLINK vendor prefix to vendor-prefixes.yaml.

 - Move the ADLINK compatible entry before PHYTEC in alphabetical order.

 - Enable open-drain configuration for LPI2C8 SCL and SDA pins.

Hardware: ADLINK LEC-iMX95
Carrier board: I-Pi SMARC Plus
SoC: NXP i.MX95

Signed-off-by: Dinesh kumar v <dinesh.v at adlinktech.com>

Dinesh kumar v (3):
  dt-bindings: vendor-prefixes: Add ADLINK
  dt-bindings: arm: fsl: Add ADLINK LEC-iMX95
  arm64: dts: imx95: Add ADLINK LEC-iMX95 board support

 .../devicetree/bindings/arm/fsl.yaml          |   6 +
 .../devicetree/bindings/vendor-prefixes.yaml  |   2 +
 arch/arm64/boot/dts/freescale/Makefile        |   1 +
 .../dts/freescale/imx95-lec-ipi-smarc.dts     | 237 ++++++++++
 arch/arm64/boot/dts/freescale/imx95-lec.dtsi  | 414 ++++++++++++++++++
 5 files changed, 660 insertions(+)
 create mode 100644 arch/arm64/boot/dts/freescale/imx95-lec-ipi-smarc.dts
 create mode 100644 arch/arm64/boot/dts/freescale/imx95-lec.dtsi

-- 
2.25.1