[PATCH v2 2/4] arm64: dts: ti: k3-am67a-beagley-ai: Add DSI0/CSI1 mux

[Rishikesh Donadkar]

On 15/05/26 06:46, Jai Luthra wrote:
> The DSI0 connector is shared withe CSI1 and selectable via the TMUX646
> switch present on the board. Model it using a gpio-mux so that camera
> sensor or DSI panel overlays can override it.
>
> Signed-off-by: Jai Luthra <jai.luthra at ideasonboard.com>


Hi Jai,

Thank you for the patch


Reviewed-by: Rishikesh Donadkar <r-donadkar at ti.com>


Rishikesh

> ---
>   arch/arm64/boot/dts/ti/k3-am67a-beagley-ai.dts | 20 ++++++++++++++++++++
>   1 file changed, 20 insertions(+)
>
> diff --git a/arch/arm64/boot/dts/ti/k3-am67a-beagley-ai.dts b/arch/arm64/boot/dts/ti/k3-am67a-beagley-ai.dts
> index 06aac02a7668..041aee2cd5b1 100644
> --- a/arch/arm64/boot/dts/ti/k3-am67a-beagley-ai.dts
> +++ b/arch/arm64/boot/dts/ti/k3-am67a-beagley-ai.dts
> @@ -146,6 +146,19 @@ led-1 {
>   			default-state = "on";
>   		};
>   	};
> +
> +	dsi_csi_mux: mux-controller {
> +		compatible = "gpio-mux";
> +		#mux-state-cells = <1>;
> +		pinctrl-names = "default";
> +		pinctrl-0 = <&dsi_csi_mux_pins_default>;
> +
> +		mux-gpios = <&main_gpio0 2 GPIO_ACTIVE_HIGH>,
> +			    <&main_gpio0 1 GPIO_ACTIVE_HIGH>;
> +
> +		/* state = SEL + 2*OE : 0 = DSI0, 1 = CSI1, 2,3 = off */
> +		idle-state = <2>;
> +	};
>   };
>   
>   &main_pmx0 {
> @@ -199,6 +212,13 @@ J722S_IOPAD(0x015c, PIN_INPUT, 0) /* (AD25) MDIO0_MDIO */
>   		>;
>   	};
>   
> +	dsi_csi_mux_pins_default: dsi-csi-mux-default-pins {
> +		pinctrl-single,pins = <
> +			J722S_IOPAD(0x0004, PIN_OUTPUT, 7) /* (L23) OSPI0_LBCLKO.GPIO0_1 */
> +			J722S_IOPAD(0x0008, PIN_OUTPUT, 7) /* (L22) OSPI0_DQS.GPIO0_2 */
> +		>;
> +	};
> +
>   	rgmii1_pins_default: rgmii1-default-pins {
>   		pinctrl-single,pins = <
>   			J722S_IOPAD(0x014c, PIN_INPUT, 0) /* (AC25) RGMII1_RD0 */
>