[PATCH] spi: zynq-qspi: Remove redundant clock enables in setup

[Gaetan Florio]

The QSPI clocks are already enabled in probe() with clk_prepare_enable().
zynq_qspi_setup_op() enables them again with clk_enable(), but the extra
enable is never balanced. This leaves the clock enable count elevated and
can trigger warnings when unbinding the driver.

Remove the redundant clock enables from the setup callback.

Signed-off-by: Gaetan Florio <gaetansjo at gmail.com>
---
 drivers/spi/spi-zynq-qspi.c | 11 -----------
 1 file changed, 11 deletions(-)

diff --git a/drivers/spi/spi-zynq-qspi.c b/drivers/spi/spi-zynq-qspi.c
index 5f23e902b..2aa2c9621 100644
--- a/drivers/spi/spi-zynq-qspi.c
+++ b/drivers/spi/spi-zynq-qspi.c
@@ -437,21 +437,10 @@ static int zynq_qspi_setup_op(struct spi_device *spi)
 {
 	struct spi_controller *ctlr = spi->controller;
 	struct zynq_qspi *qspi = spi_controller_get_devdata(ctlr);
-	int ret;
 
 	if (ctlr->busy)
 		return -EBUSY;
 
-	ret = clk_enable(qspi->refclk);
-	if (ret)
-		return ret;
-
-	ret = clk_enable(qspi->pclk);
-	if (ret) {
-		clk_disable(qspi->refclk);
-		return ret;
-	}
-
 	zynq_qspi_write(qspi, ZYNQ_QSPI_ENABLE_OFFSET,
 			ZYNQ_QSPI_ENABLE_ENABLE_MASK);
 
-- 
2.43.0