[PATCH v2] PCI: brcmstb: Assign pcie->gen from of_pci_get_max_link_speed()

[Bjorn Helgaas]

On Wed, May 06, 2026 at 09:45:37AM -0700, Florian Fainelli wrote:
> After commit 03f920936977 ("PCI: controller: Validate max-link-speed"),
> pcie->gen stopped being assigned and as a result the established PCIe
> link would stop supporting Gen3 speeds on 2712 since pcie->gen is used
> to populate LnkCntl2 and LnkCap in brcm_pcie_set_gen().
> 
> Whether the 'max-link-speed' property is not specified, or it exceeds
> Gen3, resort to the HW defaults.
> 
> Link: https://github.com/raspberrypi/linux/issues/7343
> Reported-by: Dom Cobley <popcornmix at gmail.com>
> Reported-by: Phil Elwell <phil at raspberrypi.com>
> Fixes: 03f920936977 ("PCI: controller: Validate max-link-speed")
> Signed-off-by: Florian Fainelli <florian.fainelli at broadcom.com>
> Change-Id: Ic5431469dd7a6c8b391f84f27119dad876256880

Applied to pci/for-linus for v7.1, thanks!

Sashiko pointed out a couple issues, but they're unrelated to this
patch, so I'll watch for future patches to address them.

> ---
> Changes in v2:
> 
> - utilize of_pci_get_max_link_speed() directly
> - also validate against exceeding Gen3
> 
>  drivers/pci/controller/pcie-brcmstb.c | 4 +++-
>  1 file changed, 3 insertions(+), 1 deletion(-)
> 
> diff --git a/drivers/pci/controller/pcie-brcmstb.c b/drivers/pci/controller/pcie-brcmstb.c
> index 714bcab97b60..08a0e7091ced 100644
> --- a/drivers/pci/controller/pcie-brcmstb.c
> +++ b/drivers/pci/controller/pcie-brcmstb.c
> @@ -2072,8 +2072,10 @@ static int brcm_pcie_probe(struct platform_device *pdev)
>  		return PTR_ERR(pcie->clk);
>  
>  	ret = of_pci_get_max_link_speed(np);
> -	if (pcie_get_link_speed(ret) == PCI_SPEED_UNKNOWN)
> +	if (ret < 0 || ret > 3)
>  		pcie->gen = 0;
> +	else
> +		pcie->gen = ret;
>  
>  	pcie->ssc = of_property_read_bool(np, "brcm,enable-ssc");
>  
> -- 
> 2.34.1
>