[PATCH 1/4] ARM: dts: imx6qdl-sabrelite: add mdio phy address 0

[Frank Li]

On Tue, May 12, 2026 at 12:15:08AM +0200, Andrew Lunn wrote:
> On Mon, May 11, 2026 at 05:04:56PM -0400, Frank Li wrote:
> > According to IEEE 802.3 Clause 22.2.4.5.5 PHYAD (PHY Address), A PHY that
> > is connected to the station management entity via the mechanical interface
> > defined in 22.6 shall always respond to transactions addressed to PHY
> > Address zero <00000>.
>
> Did you read 22.6? I've not seen a mechanical interface as defined in
> 22.6 for at least 20 years, maybe 30 years.
>
> That cause does not apply in this context.

Thanks, I missed understand it. This board is still alive, let me double
check it.

Frank

>
> > -		ethphy: ethernet-phy {
> > +		ethphy: ethernet-phy at 0 {
> >  			compatible = "ethernet-phy-ieee802.3-c22";
> > +			reg = <0>;
>
> This could very well break this board. Without a reg value, the core
> will find the first PHY on the bus, at whatever address it is at. If
> you hard code 0, the PHY must be at 0, otherwise it will not be found.
>
> 	Andrew