[PATCH 4/4] arm64: dts: cix: add Sky1 USB4 and USB5 controllers

[Peter Chen]

Add the Sky1 USB4 and USB5 Cadence USB3 controller nodes with their
registers, interrupts, clocks, resets and S5 syscon control. Enable both
ports on the Orion O6 board in host mode with the required VBUS pinctrl.

Signed-off-by: Peter Chen <peter.chen at cixtech.com>
---
 arch/arm64/boot/dts/cix/sky1-orion-o6.dts | 30 ++++++++++
 arch/arm64/boot/dts/cix/sky1.dtsi         | 68 +++++++++++++++++++++++
 2 files changed, 98 insertions(+)

diff --git a/arch/arm64/boot/dts/cix/sky1-orion-o6.dts b/arch/arm64/boot/dts/cix/sky1-orion-o6.dts
index e39c87774c12..d1e2afceea15 100644
--- a/arch/arm64/boot/dts/cix/sky1-orion-o6.dts
+++ b/arch/arm64/boot/dts/cix/sky1-orion-o6.dts
@@ -80,6 +80,22 @@ pins {
 
 		};
 	};
+
+	pinctrl_usb4: usb4-power-on-cfg {
+		pins {
+			pinmux = <CIX_PAD_GPIO041_FUNC_USB_DRIVE_VBUS4>;
+			bias-pull-down;
+			drive-strength = <8>;
+		};
+	};
+
+	pinctrl_usb5: usb5-power-on-cfg {
+		pins {
+			pinmux = <CIX_PAD_GPIO042_FUNC_USB_DRIVE_VBUS5>;
+			bias-pull-down;
+			drive-strength = <8>;
+		};
+	};
 };
 
 &pcie_x8_rc {
@@ -117,3 +133,17 @@ &s5_gpio2 {
 &uart2 {
 	status = "okay";
 };
+
+&usb4 {
+	pinctrl-names = "default";
+	pinctrl-0 = <&pinctrl_usb4>;
+	dr_mode = "host";
+	status = "okay";
+};
+
+&usb5 {
+	pinctrl-names = "default";
+	pinctrl-0 = <&pinctrl_usb5>;
+	dr_mode = "host";
+	status = "okay";
+};
diff --git a/arch/arm64/boot/dts/cix/sky1.dtsi b/arch/arm64/boot/dts/cix/sky1.dtsi
index bb5cfb1f2113..9f7d9ad6586c 100644
--- a/arch/arm64/boot/dts/cix/sky1.dtsi
+++ b/arch/arm64/boot/dts/cix/sky1.dtsi
@@ -6,6 +6,8 @@
 
 #include <dt-bindings/interrupt-controller/arm-gic.h>
 #include <dt-bindings/clock/cix,sky1.h>
+#include <dt-bindings/phy/phy.h>
+#include <dt-bindings/reset/cix,sky1-s5-system-control.h>
 #include "sky1-power.h"
 
 / {
@@ -504,6 +506,72 @@ mbox_ap2sfh: mailbox at 80a0000 {
 			cix,mbox-dir = "tx";
 		};
 
+		usb4: usb at 91d0000 {
+			compatible = "cix,sky1-usb3", "cix,cdns-usb3";
+			reg = <0x00 0x91d0000 0x00 0x4000>,
+					<0x00 0x91d4000 0x00 0x4000>,
+					<0x00 0x91d8000 0x00 0x8000>,
+					<0x00 0x91c0314 0x00 0x4>;
+			reg-names = "otg", "dev", "xhci", "glue";
+
+			interrupts = <GIC_SPI 252 IRQ_TYPE_LEVEL_HIGH 0>,	/* host irq */
+					<GIC_SPI 252 IRQ_TYPE_LEVEL_HIGH 0>,	/* peripheral irq */
+					<GIC_SPI 253 IRQ_TYPE_LEVEL_HIGH 0>,	/* otgirq */
+					<GIC_SPI 252 IRQ_TYPE_LEVEL_HIGH 0>;	/* wakeup irq */
+			interrupt-names = "host",
+					"peripheral",
+					"otg",
+					"wakeup";
+
+			resets = <&s5_syscon SKY1_USBC_SS2_PRST_N>,
+				<&s5_syscon SKY1_USBC_SS2_RST_N>;
+			reset-names = "prst", "rst";
+
+			clocks = <&scmi_clk CLK_TREE_USB3A_H0_CLK_SOF>,
+				<&scmi_clk CLK_TREE_USB3A_0_AXI_GATE>,
+				<&scmi_clk CLK_TREE_USB3A_H0_CLK_LPM>,
+				<&scmi_clk CLK_TREE_USB3A_0_APB_GATE>;
+			clock-names = "sof", "aclk", "lpm", "pclk";
+
+			cix,syscon-usb = <&s5_syscon>;
+			dma-coherent;
+			maximum-speed = "super-speed-plus";
+			dr_mode = "otg";
+		};
+
+		usb5: usb at 91e0000 {
+			compatible = "cix,sky1-usb3", "cix,cdns-usb3";
+			reg = <0x00 0x91e0000 0x00 0x4000>,
+					<0x00 0x91e4000 0x00 0x4000>,
+					<0x00 0x91e8000 0x00 0x8000>,
+					<0x00 0x91c0324 0x00 0x4>;
+			reg-names = "otg", "dev", "xhci", "glue";
+
+			interrupts = <GIC_SPI 257 IRQ_TYPE_LEVEL_HIGH 0>,	/* host irq */
+					<GIC_SPI 257 IRQ_TYPE_LEVEL_HIGH 0>,	/* peripheral irq */
+					<GIC_SPI 258 IRQ_TYPE_LEVEL_HIGH 0>,	/* otgirq */
+					<GIC_SPI 257 IRQ_TYPE_LEVEL_HIGH 0>;	/* wakeup irq */
+			interrupt-names = "host",
+					"peripheral",
+					"otg",
+					"wakeup";
+
+			resets = <&s5_syscon SKY1_USBC_SS3_PRST_N>,
+				<&s5_syscon SKY1_USBC_SS3_RST_N>;
+			reset-names = "prst", "rst";
+
+			clocks = <&scmi_clk CLK_TREE_USB3A_H1_CLK_SOF>,
+				<&scmi_clk CLK_TREE_USB3A_1_AXI_GATE>,
+				<&scmi_clk CLK_TREE_USB3A_H1_CLK_LPM>,
+				<&scmi_clk CLK_TREE_USB3A_1_APB_GATE>;
+			clock-names = "sof", "aclk", "lpm", "pclk";
+
+			cix,syscon-usb = <&s5_syscon>;
+			dma-coherent;
+			maximum-speed = "super-speed-plus";
+			dr_mode = "otg";
+		};
+
 		pcie_x8_rc: pcie at a010000 {
 			compatible = "cix,sky1-pcie-host";
 			reg = <0x00 0x0a010000 0x00 0x10000>,
-- 
2.50.1