[PATCH v3] arm64: dts: imx8mp: Add DT overlays for DH i.MX8M Plus DHCOM SoM and boards

[Frank Li]

On Fri, May 08, 2026 at 06:11:23PM +0200, Marek Vasut wrote:
> On 3/26/26 5:43 AM, Marek Vasut wrote:
> > Add DT overlays to support DH i.MX8M Plus DHCOM SoM variants and carrier
> > board expansion modules. The following DT overlays are implemented:
> > - SoM:
> >    - DH 660-x00 SoM with 1xRMII PHY
> >    - DH 660-x00 SoM with 2xRMII PHY
> > - PDK2:
> >    - DH 505-200 Display board in edge connector X12 via direct LVDS
> >    - DH 531-100 SPI/I2C board in header X21
> >    - DH 531-200 SPI/I2C board in header X22
> >    - DH 560-200 Display board in edge connector X12
> > - PDK3:
> >    - DH 505-200 Display board in edge connector X36 via direct LVDS
> >    - DH 531-100 SPI/I2C board in header X40
> >    - DH 531-200 SPI/I2C board in header X41
> >    - DH 560-300 Display board in edge connector X36
> >    - EA muRata 2AE M.2 A/E-Key card in connector X20
> >    - NXP SPF-29853-C1 MINISASTOCSI with OV5640 sensor in connector X31
> >    - NXP SPF-29853-C1 MINISASTOCSI with OV5640 sensor in connector X29
> > - PicoITX:
> >    - DH 626-100 Display board in edge connector X2
> Hello Frank,
>
> how can we proceed with this patch ?
>
> I hope all the feedback has been addressed ?

It is similar case of dtso for adaptor, which more complex because there
two similar slot x21 and x22.

let us wait for a little bit while.

Frank