[RFC PATCH 0/4] arm64: realm: Support for probing RSI earlier

Lorenzo Pieralisi lpieralisi at kernel.org
Fri May 8 01:09:08 PDT 2026


On Wed, Apr 29, 2026 at 11:35:31AM +0100, Suzuki K Poulose wrote:
> The Realm Guest linux support is broken without rodata=full (fortunately default
> for arm64), as we detect the RSI support after we have created the Linear map
> with Block/Contiguous mappings. If the boot CPU doesn't support BBML2_NOABORT
> (there are CPUs out there with FEAT_RME and no - useable - BBML2_NOABORT)
> we are then not able to split the page tables down to PTE level if the system
> as such doesn't support BBML2.
> 
> See the following link for the discussion.
> 
> https://lore.kernel.org/all/20260330161705.3349825-2-ryan.roberts@arm.com/
> 
> The available options are :
>  1. Start with PTE level mappings at paging_init() and then "FOLD" the page tables
>     to Block/Cont mappings after we have the full picture available. Looking at the
>     future (with BBML3), this might mean "additional work" for most of the systems
>     at boot. But not bad as splitting them ?
>  2. Hold the secondary CPUs in busy loop with MMU disabled and split the mappings
>     by the boot CPU with MMU off (if Boot CPU can't support BBML2). This is tricky
>     with the page allocations required to add the page-tables.
>  3. Move the detection of Realm support earlier to make a better decision for
>     paging_init(), with an added bonus of earlycon support for Realms without
>     the user having to work out the "top bit" for the Realm.
> 
> This series is an attempt to implement (3) (without the earlycon support). We try
> to probe the PSCI conduit early from the DT/ACPI. DT is not flattened at this time.

Nit: you mean unflattened here.

> ACPI table is not mapped in full, so we have to map one table at a time and walk
> from the Root of the table (RSDP) through to XSDT and find the FADT table from
> the array of table pointers there. Minimal verification is performed on the 
> tables (e.g., revision checks, standard FADT sanity checks). Checksum is not
> verified, but should be possible to do for the parts we consume.

I went back to tracing acpi_boot_table_init() (joy :)) and it does what you
describe here above (it has been a while since I touched that code) relying on
early_memremap() mappings (as you re-do in this series) before acpi_permanent_mmap
is set in acpi_early_init() (that happens later in the boot process).

I am sure there are caveats in moving acpi_boot_table_init() before
paging_init() but I thought I'd mention it in case (3) is what we are
pursuing (I am most definitely in favour of alternatives if there are
any).

> With arm64, during the normal boot, we could fallback to using DT if the ACPI
> tables are not useable. So, during the early probe, we try to follow the similar
> logic and probe the conduit from both DT and ACPI where available. If both of
> them contain a conduit, we only proceed if they match. Otherwise, we skip the
> early probe and do things the normal way. (Any sane system shouldn't have such
> a mismatch, but..)
> 
> Once we probe the PSCI conduit, PSCI is probed, along with the presence of SMCCC.
> With that in place, we try to probe the RSI support after the early probe and
> advertise the Realm World. If the early probe wasn't successful, we fall back
> to the late mode, where we could end up with (on a possibly rare broken firmware).
> 
> NOTE: This is an early RFC attempt to moving the PSCI detection earlier. The other
> option(s) that may be worth exploring are:
> 
> 1. On systems with EFI, parse this from EFI Stub and pass the data back in the
>    DT Stub, under chosen node. e.g., "linux,uefi-arm-psci-conduit".
>    Challenge: EFI stub doesn't seem to be ACPI aware. We could make that change,
>    we only need a few table walks.

What would we gain compared to (3) above ?

Thanks,
Lorenzo

> 2. Have EFI firmware provide this information (with my limited knowledge on the
>    area, this looks like too much work, and bending the standards)
> 3. Append arm64 boot protocol to have this information passed to the kernel.
>    (Firmware provided) - (Steven's idea)
> 4. Any other options ?
> 
> 
> This series is also available here :
> 
> git at git.gitlab.arm.com:linux-arm/linux-cca.git	cca-guest/early-rsi-detection/rfc-v1
> 
> Thoughts ?
> 
> Suzuki
> 
> 
> Suzuki K Poulose (4):
>   arm64: acpi: Refactor FADT table verification
>   psci: Add support for Early detection and init
>   arm64: psci: Move detection and SMCCC probe earlier
>   arm64: realm: Move RSI detection earlier
> 
>  arch/arm64/include/asm/acpi.h |   1 +
>  arch/arm64/include/asm/rsi.h  |   1 +
>  arch/arm64/kernel/acpi.c      | 136 +++++++++++++++++++++++++++-------
>  arch/arm64/kernel/rsi.c       |  23 +++++-
>  arch/arm64/kernel/setup.c     |  69 +++++++++++++++++
>  drivers/firmware/psci/psci.c  |  49 +++++++++++-
>  include/linux/psci.h          |   2 +
>  7 files changed, 252 insertions(+), 29 deletions(-)
> 
> -- 
> 2.43.0
> 



More information about the linux-arm-kernel mailing list