[PATCH 10/13] arm64: dts: ti: k3-j721e-common-proc-board: fix USB clocking for compliance

[Siddharth Vadapalli]

According to section "6.5.3 Normative Spread Spectrum Clocking (SSC)" of
the USB 3.2 Specification, SSC should be enabled by default. This protects
against EMI violations. Hence, enable internal SSC for USB SuperSpeed.

Fixes: 02c35dca2b48 ("arm64: dts: ti: k3-j721e: Enable Super-Speed support for USB0")
Cc: <stable at vger.kernel.org>
Signed-off-by: Siddharth Vadapalli <s-vadapalli at ti.com>
---
 arch/arm64/boot/dts/ti/k3-j721e-common-proc-board.dts | 6 ++++++
 1 file changed, 6 insertions(+)

diff --git a/arch/arm64/boot/dts/ti/k3-j721e-common-proc-board.dts b/arch/arm64/boot/dts/ti/k3-j721e-common-proc-board.dts
index 53e7fbcef52b..b25bce995b64 100644
--- a/arch/arm64/boot/dts/ti/k3-j721e-common-proc-board.dts
+++ b/arch/arm64/boot/dts/ti/k3-j721e-common-proc-board.dts
@@ -531,6 +531,11 @@ &serdes_ln_ctrl {
 &serdes_wiz3 {
 	typec-dir-gpios = <&main_gpio1 3 GPIO_ACTIVE_HIGH>;
 	typec-dir-debounce-ms = <700>;	/* TUSB321, tCCB_DEFAULT 133 ms */
+	ti,core-clk-sel = <1>;  /* Select internal reference clock */
+	ti,ssc-enable; /* Enable SSC */
+	ti,ssc-type = <1>; /* 1 for Downspread */
+	ti,ssc-frequency-hz = <33000>; /* 33 KHz */
+	ti,ssc-depth-per-mil = <5>; /* 0.5% depth */
 };
 
 &serdes3 {
@@ -539,6 +544,7 @@ serdes3_usb_link: phy at 0 {
 		cdns,num-lanes = <2>;
 		#phy-cells = <0>;
 		cdns,phy-type = <PHY_TYPE_USB3>;
+		cdns,ssc-mode = <2>; /* 2 for internal SSC */
 		resets = <&serdes_wiz3 1>, <&serdes_wiz3 2>;
 		bootph-all;
 	};
-- 
2.51.1