[PATCH 11/11] arm64: dts: renesas: gray-hawk: Specify ethernet PHY reset timings

[Marek Vasut]

The KSZ9031RNX reference manual [1] DS00002096H page 60 FIGURE 7-7:
POWER-UP/POWER-DOWN/RESET TIMING Note 2 states, that after the
de-assertion of reset, wait a minimum of 100 us before starting
programming on the MIIM (MDC/MDIO) interface. Set DT property
reset-deassert-us to three times that, 300 us, to provide ample
time between reset deassertion and MDIO access.

The KSZ9031RNX reference manual [1] DS00002096H page 60 TABLE 7-7:
POWER-UP/POWER-DOWN/RESET TIMING PARAMETERS row tSR Stable supply
voltages to de-assertion of reset is at minimum 10 ms. Set DT
property reset-assert-us to 10ms because the KSZ9031RNX RM does
not explicitly spell out how long the reset has to be asserted,
but this at least covers the worst case scenario.

[1] https://ww1.microchip.com/downloads/aemDocuments/documents/UNG/ProductDocuments/DataSheets/KSZ9031MNX-Data-Sheet-DS00002096.pdf

Signed-off-by: Marek Vasut <marek.vasut+renesas at mailbox.org>
---
Cc: Conor Dooley <conor+dt at kernel.org>
Cc: Geert Uytterhoeven <geert+renesas at glider.be>
Cc: Krzysztof Kozlowski <krzk+dt at kernel.org>
Cc: Magnus Damm <magnus.damm at gmail.com>
Cc: Rob Herring <robh at kernel.org>
Cc: devicetree at vger.kernel.org
Cc: linux-kernel at vger.kernel.org
Cc: linux-renesas-soc at vger.kernel.org
---
 arch/arm64/boot/dts/renesas/gray-hawk-single.dtsi | 2 ++
 1 file changed, 2 insertions(+)

diff --git a/arch/arm64/boot/dts/renesas/gray-hawk-single.dtsi b/arch/arm64/boot/dts/renesas/gray-hawk-single.dtsi
index 792a4aa8f4a9d..274493720b14e 100644
--- a/arch/arm64/boot/dts/renesas/gray-hawk-single.dtsi
+++ b/arch/arm64/boot/dts/renesas/gray-hawk-single.dtsi
@@ -213,6 +213,8 @@ avb0_phy: ethernet-phy at 0 {
 			reg = <0>;
 			interrupts-extended = <&gpio7 5 IRQ_TYPE_LEVEL_LOW>;
 			reset-gpios = <&gpio7 10 GPIO_ACTIVE_LOW>;
+			reset-assert-us = <10000>;
+			reset-deassert-us = <300>;
 		};
 	};
 };
-- 
2.53.0