[PATCH 2/2] PCI: j721e: Set max_link_speed to enable 100 ms delay after link up

[Hans Zhang]

Set cdns_pcie.max_link_speed to the maximum supported link speed
(obtained from the device tree property "max-link-speed") in
j721e_pcie_set_link_speed(). This activates the post-link delay logic
added in cdns_pcie_host_wait_for_link() when the controller supports
speeds greater than 5 GT/s.

As required by PCIe r6.0 sec 6.6.1, and following the same approach as
commit 80dc18a0cba8d ("PCI: dwc: Ensure that dw_pcie_wait_for_link()
waits 100 ms after link up"), this ensures a 100 ms delay after link
training completes before any Configuration Request is sent.

Signed-off-by: Hans Zhang <18255117159 at 163.com>
---
 drivers/pci/controller/cadence/pci-j721e.c | 1 +
 1 file changed, 1 insertion(+)

diff --git a/drivers/pci/controller/cadence/pci-j721e.c b/drivers/pci/controller/cadence/pci-j721e.c
index bfdfe98d5aba..ee85b8e04f5b 100644
--- a/drivers/pci/controller/cadence/pci-j721e.c
+++ b/drivers/pci/controller/cadence/pci-j721e.c
@@ -206,6 +206,7 @@ static int j721e_pcie_set_link_speed(struct j721e_pcie *pcie,
 	    (pcie_get_link_speed(link_speed) == PCI_SPEED_UNKNOWN))
 		link_speed = 2;
 
+	pcie->cdns_pcie.max_link_speed = link_speed;
 	val = link_speed - 1;
 	ret = regmap_update_bits(syscon, offset, GENERATION_SEL_MASK, val);
 	if (ret)
-- 
2.34.1