[RFC PATCH] arm64: dts: imx8mp-edm-g-wb: Use 0 for reserved bit

[Frank Li]

On Tue, Mar 10, 2026 at 09:10:53AM +0000, Eduard Bostina wrote:

Remove RFC.

> The i.MX8MP Reference Manual documents bit 0 of the
> IOMUXC_SW_PAD_CTL_PAD registers as reserved. The hd3ss3220
> IRQ pin (SAI1_RXD6/GPIO4_IO08) currently uses pad config
> value 0x41 which sets this reserved bit.
>
> Change 0x41 to 0x40 to leave the reserved bit cleared, as
> recommended by the reference manual.

Any impact if set bit 0 to 1?

> This also allows for
> easier conversion to symbolic macros.

Can you send this patch also?

Frank
>
> Signed-off-by: Eduard Bostina <egbostina at gmail.com>
> ---
>  arch/arm64/boot/dts/freescale/imx8mp-edm-g-wb.dts | 2 +-
>  1 file changed, 1 insertion(+), 1 deletion(-)
>
> diff --git a/arch/arm64/boot/dts/freescale/imx8mp-edm-g-wb.dts b/arch/arm64/boot/dts/freescale/imx8mp-edm-g-wb.dts
> index 242fa930b..a78401d11 100644
> --- a/arch/arm64/boot/dts/freescale/imx8mp-edm-g-wb.dts
> +++ b/arch/arm64/boot/dts/freescale/imx8mp-edm-g-wb.dts
> @@ -345,7 +345,7 @@ MX8MP_IOMUXC_SAI1_TXD5__GPIO4_IO17		0x16 /* DSI_VDDEN */
>
>  	pinctrl_hd3ss3220_irq: hd3ss3220-irqgrp {
>  		fsl,pins = <
> -			MX8MP_IOMUXC_SAI1_RXD6__GPIO4_IO08		0x41 /* GPIO_P253 */
> +			MX8MP_IOMUXC_SAI1_RXD6__GPIO4_IO08		0x40 /* GPIO_P253 */
>  		>;
>  	};
>
> --
> 2.43.0
>