[PATCH v20 08/10] arm64: dts: qcom: lemans: Add psci reboot-modes

[Shivendra Pratap]

On 05-03-2026 17:03, Konrad Dybcio wrote:
> On 3/4/26 7:03 PM, Shivendra Pratap wrote:
>> Add PSCI SYSTEM_RESET2 reboot-modes for lemans based boards, for use by
>> the psci_reboot_mode driver.
>>
>> The following modes are defined:
>> - bootloader: reboot into fastboot mode for fastboot flashing.
>> - edl: reboot into emergency download mode for image loading via
>>    the Firehose protocol.
>>
>> Support for these modes is firmware dependent.
> 
> The previous patch only enabled it on a subset of kodiak boards,
> the remaining ones do it globally, even though you claim it's fw
> dependent.. this changed in in v17 apparently
> 

Thanks. Let me review this and make it board specific wherever required.
Will update this in next patch.

> My fear is that those may conflict with other methods providing
> identical identification names, i.e.:
> 
> psci {
> 	reboot-mode {
> 		mode-bootloader = <0x80010001 0x2>;
> 		mode-edl = <0x80000000 0x1>;
> 	};
> };
> 
> imem at f000 {
> 	reboot-mode {
> 		compatible = "syscon-reboot-mode";
> 		offset = <0x65c>;
> 
> 		mode-normal = <0x77665501>;
> 		mode-bootloader = <0x77665500>; // conflict
> 		mode-recovery = <0x77665502>;
> 	};
> };
> 
> will the syscon write apply and the (unsupported) PSCI_RESET2 gracefully
> fall through?
If a SOC/board wants to use "syscon-reboot-mode" / "nvmem-reboot-mode" / 
psci->reboot-mode, has to be taken care in the DT as per support. Will 
make it board specific wherever required after re-review of the DTs.

thanks,
Shivendra