[PATCH v2 2/2] arm64: dts: tqma9352-mba91xxca: Change Ethernet PHY IRQ to IRQ_TYPE_LEVEL_LOW

[Alexander Stein]

Ethernet PHY interrupt mode is level triggered. Adjust the mode
accordingly.

Signed-off-by: Alexander Stein <alexander.stein at ew.tq-group.com>
---
Changes in v2:
* Adjusted the subject

 arch/arm64/boot/dts/freescale/imx93-tqma9352-mba91xxca.dts | 4 ++--
 1 file changed, 2 insertions(+), 2 deletions(-)

diff --git a/arch/arm64/boot/dts/freescale/imx93-tqma9352-mba91xxca.dts b/arch/arm64/boot/dts/freescale/imx93-tqma9352-mba91xxca.dts
index 2673d9dccbf4b..737326ba1b2a7 100644
--- a/arch/arm64/boot/dts/freescale/imx93-tqma9352-mba91xxca.dts
+++ b/arch/arm64/boot/dts/freescale/imx93-tqma9352-mba91xxca.dts
@@ -232,7 +232,7 @@ ethphy_eqos: ethernet-phy at 0 {
 			reset-assert-us = <500000>;
 			reset-deassert-us = <50000>;
 			interrupt-parent = <&gpio3>;
-			interrupts = <26 IRQ_TYPE_EDGE_FALLING>;
+			interrupts = <26 IRQ_TYPE_LEVEL_LOW>;
 			enet-phy-lane-no-swap;
 			ti,rx-internal-delay = <DP83867_RGMIIDCTL_2_25_NS>;
 			ti,tx-internal-delay = <DP83867_RGMIIDCTL_2_25_NS>;
@@ -265,7 +265,7 @@ ethphy_fec: ethernet-phy at 0 {
 			reset-assert-us = <500000>;
 			reset-deassert-us = <50000>;
 			interrupt-parent = <&gpio3>;
-			interrupts = <27 IRQ_TYPE_EDGE_FALLING>;
+			interrupts = <27 IRQ_TYPE_LEVEL_LOW>;
 			enet-phy-lane-no-swap;
 			ti,rx-internal-delay = <DP83867_RGMIIDCTL_2_25_NS>;
 			ti,tx-internal-delay = <DP83867_RGMIIDCTL_2_25_NS>;
-- 
2.43.0