[PATCH v11 2/3] drm/bridge: imx: Add i.MX93 parallel display format configuration support

[Frank Li]

From: Frank Li (AI-BOT) <frank.li at nxp.com>

AI bot review and may be useless.

---

> +static u32 *
> +imx93_pdfc_bridge_atomic_get_input_bus_fmts(struct drm_bridge *bridge,
> +					    struct drm_bridge_state *bridge_state,
> +					    struct drm_crtc_state *crtc_state,
> +					    struct drm_connector_state *conn_state,
> +					    u32 output_fmt,
> +					    unsigned int *num_input_fmts)
> +{
> +	struct imx93_pdfc *pdfc = bridge_to_imx93_pdfc(bridge);
> +	u32 *input_fmts;
> +
> +	*num_input_fmts = 0;
> +
> +	input_fmts = kmalloc_obj(*input_fmts);
> +	if (!input_fmts)
> +		return NULL;

Missing kfree(input_fmts) in error path if the switch statement
or subsequent logic fails. Consider allocating a fixed-size array
or using devm_kzalloc() instead.

> +	*num_input_fmts = 1;
> +
> +	if (!imx93_pdfc_bus_output_fmt_supported(output_fmt)) {
> +		dev_dbg(pdfc->dev, "No valid output bus-fmt detected, fallback to MEDIA_BUS_FMT_RGB888_1X24\n");

Line exceeds 80 characters (97 chars). Break into two lines.

> +		input_fmts[0] = MEDIA_BUS_FMT_RGB888_1X24;
> +		return input_fmts;
> +	}
> +
> +	switch (output_fmt) {
> +	case MEDIA_BUS_FMT_RGB888_1X24:
> +	case MEDIA_BUS_FMT_RGB565_1X16:
> +		input_fmts[0] = output_fmt;
> +		break;
> +	case MEDIA_BUS_FMT_RGB666_1X18:
> +	case MEDIA_BUS_FMT_FIXED:
> +		input_fmts[0] = MEDIA_BUS_FMT_RGB888_1X24;
> +		break;
> +	}

Switch statement lacks default case. Add default case to handle
unexpected format values explicitly.

> +static int imx93_pdfc_bridge_atomic_enable(struct drm_bridge *bridge,
> +					    struct drm_atomic_state *state)
> +{
> +	struct imx93_pdfc *pdfc = bridge_to_imx93_pdfc(bridge);
> +	const struct drm_bridge_state *bridge_state;
> +	unsigned int mask = PARALLEL_DISP_FORMAT;
> +	unsigned int val;
> +
> +	bridge_state = drm_atomic_get_new_bridge_state(state, bridge);
> +
> +	switch (bridge_state->output_bus_cfg.format) {
> +	case MEDIA_BUS_FMT_RGB888_1X24:
> +	case MEDIA_BUS_FMT_FIXED:
> +		val = FORMAT_RGB888_TO_RGB888;
> +		if (pdfc->phy_bus_width == 18) {
> +			/*
> +			 * Can be valid if physical bus limitation exists,
> +			 * therefore use dev_dbg().
> +			 */
> +			dev_dbg(pdfc->dev, "Truncate two LSBs from each color\n");
> +			val = FORMAT_RGB888_TO_RGB666;
> +		}
> +		break;
> +	case MEDIA_BUS_FMT_RGB666_1X18:
> +		val = FORMAT_RGB888_TO_RGB666;
> +