[PATCH v4 0/7] Add initial Exynos850 support to the thermal driver

[Mateusz Majewski]

Hello and sorry for missing your mail, thankfully Marek pointed it out
to me.

> I applied the whole series locally, it applies fine on 6.19 but I didn't
> check linux-next; and tested it on Exynos850 E850-96 board with the
> following DT node:
> 
> tmuctrl_0: tmu at 10070000 {
>     compatible = "samsung,exynos850-tmu";
>     reg = <0x10070000 0x800>;
>     interrupts = <GIC_SPI 226 IRQ_TYPE_LEVEL_HIGH>;
>     clocks = <&cmu_peri CLK_GOUT_BUSIF_TMU_PCLK>;
>     clock-names = "tmu_apbif";
>     #thermal-sensor-cells = <0>;
> };
> 
> and thermal zones as you mentioned way back. It works just fine.
> Temp goes up to 48 C with a loaded CPUs and settles at 36-37C when idle.
> 
> So for the whole series:
> Tested-by: Alexey Klimov <alexey.klimov at linaro.org>

Thank you!

> However, do you have plans to update it or re-submit?
> Or any other plans working on it?

Honestly not sure. If any other patches are merged that conflict with
this series, I definitely can resolve the commits (for now it applies
just fine to next-20260227, though I haven't compiled the result yet).
Correct me if I am wrong, but I don't recall anything to be done in this
series otherwise. If there is interest in this series, I can retest this
on the other boards and re-submit this later this week.

Kind regards,
Mateusz Majewski