[PATCH v4 2/3] usb: dwc3: add needs_full_reinit flag

[Thinh Nguyen]

On Fri, Feb 27, 2026, Randy Dunlap wrote:
> Hi--
> 
> On 2/12/26 12:35 AM, Xu Yang wrote:
> > The current design assumes that the controller remains powered when wakeup
> > is enabled. However, some SoCs provide wakeup capability even when the
> > controller itself is powered down, using separate dedicated wakeup logic.
> > This allows additional power savings, but requires the controller to be
> > fully re‑initialized after system resume.
> > 
> > To support these SoCs, introduce a flag needs_full_reinit for the purpose.
> > And the glue layer needs to indicate if the controller needs this behavior
> > by setting a same flag needs_full_reinit in dwc3_properties.
> > 
> > Reviewed-by: Frank Li <Frank.Li at nxp.com>
> > Signed-off-by: Xu Yang <xu.yang_2 at nxp.com>
> > ---
> > Changes in v4:
> >  - also rename core_may_lose_power to needs_full_reinit
> >  - add R-b tag
> > Changes in v3:
> >  - no changes
> > Changes in v2:
> >  - put core_may_lose_power into dwc3_properties and check it in
> >    dwc3_get_software_properties()
> >  - rename may_lose_power to needs_full_reinit
> > ---
> >  drivers/usb/dwc3/core.c | 9 +++++++--
> >  drivers/usb/dwc3/core.h | 3 +++
> >  drivers/usb/dwc3/glue.h | 3 +++
> >  3 files changed, 13 insertions(+), 2 deletions(-)
> > 
> 
> > diff --git a/drivers/usb/dwc3/core.h b/drivers/usb/dwc3/core.h
> > index a35b3db1f9f3..67bcc8dccc89 100644
> > --- a/drivers/usb/dwc3/core.h
> > +++ b/drivers/usb/dwc3/core.h
> > @@ -1119,6 +1119,8 @@ struct dwc3_glue_ops {
> >   * @usb3_lpm_capable: set if hadrware supports Link Power Management
> >   * @usb2_lpm_disable: set to disable usb2 lpm for host
> >   * @usb2_gadget_lpm_disable: set to disable usb2 lpm for gadget
> > + * @needs_full_reinit: set to indicate the core may lose power and need full
> > +			initialization during system pm
> 
> The line above should begin with
>  *
> 
> Please correct it so that kernel-doc doesn't complain:
> 
> WARNING: drivers/usb/dwc3/core.h:1122 bad line:                         initialization during system pm
> 
> Thanks.
> 

Thanks Randy, I missed this during review.


Hi Xu,

Do you think you can send a fix for this?

Thanks,
Thinh