[PATCH 10/10] arm64: dts: qcom: sdm845-google: Add STM FTS touchscreen support

[Konrad Dybcio]

On 3/1/26 6:51 PM, David Heidelberg via B4 Relay wrote:
> From: Petr Hodina <petr.hodina at protonmail.com>
> 
> Basic touchscreen connected to second i2c bus.
> 
> Signed-off-by: Petr Hodina <petr.hodina at protonmail.com>
> Co-developed-by: David Heidelberg <david at ixit.cz>
> Signed-off-by: David Heidelberg <david at ixit.cz>
> ---
>  arch/arm64/boot/dts/qcom/sdm845-google-blueline.dts | 21 ++++++++++++++++++++-
>  1 file changed, 20 insertions(+), 1 deletion(-)
> 
> diff --git a/arch/arm64/boot/dts/qcom/sdm845-google-blueline.dts b/arch/arm64/boot/dts/qcom/sdm845-google-blueline.dts
> index fa89be500fb85..2501104b06e1b 100644
> --- a/arch/arm64/boot/dts/qcom/sdm845-google-blueline.dts
> +++ b/arch/arm64/boot/dts/qcom/sdm845-google-blueline.dts
> @@ -26,7 +26,26 @@ &i2c2 {
>  
>  	status = "okay";
>  
> -	/* ST,FTS @ 49 */
> +	touchscreen at 49 {
> +		compatible = "st,stmfts5";
> +		reg = <0x49>;
> +
> +		pinctrl-0 = <&touchscreen_pins &touchscreen_reset>;
> +		pinctrl-names = "default";
> +
> +		interrupt-parent = <&tlmm>;
> +		interrupts = <125 IRQ_TYPE_LEVEL_LOW>;
> +
> +		irq-gpios = <&tlmm 125 GPIO_ACTIVE_HIGH>;

This is an anti-pattern - you can translate the GPIO handle to an
IRQ handle, but unless the hardware is spectacularly odd, an interrupt
reference is usually what you're after

> +		switch-gpios = <&tlmm 136 GPIO_ACTIVE_HIGH>;
> +		reset-gpios = <&tlmm 99 GPIO_ACTIVE_LOW>;
> +
> +		avdd-supply = <&vreg_l14a_1p8>;
> +		vdd-supply = <&vreg_l19a_3p3>;
> +
> +		touchscreen-size-x = <1079>;
> +		touchscreen-size-y = <2159>;

Are you sure about these off-by-ones?

FWIW

input/touchscreen.c:

touchscreen_get_prop_u32(dev, "touchscreen-size-x",
                         input_abs_get_max(input,
                                           axis_x) + 1,

				            notice ^

Konrad