[PATCH 04/13] sh: replace linux/gpio.h inclusions

[Philippe Mathieu-Daudé]

On 29/6/26 15:26, Arnd Bergmann wrote:
> From: Arnd Bergmann <arnd at arndb.de>
> 
> linux/gpio.h should no longer be used, convert these instead to
> linux/gpio/legacy.h for the sh boards using the legacy interfaces,
> or remove it where it is not needed at all.
> 
> Signed-off-by: Arnd Bergmann <arnd at arndb.de>
> ---
>   arch/sh/boards/board-magicpanelr2.c             | 2 +-
>   arch/sh/boards/board-sh7757lcr.c                | 2 +-
>   arch/sh/boards/board-urquell.c                  | 2 +-
>   arch/sh/boards/mach-ap325rxa/setup.c            | 2 +-
>   arch/sh/boards/mach-ecovec24/setup.c            | 2 +-
>   arch/sh/boards/mach-highlander/pinmux-r7785rp.c | 2 +-
>   arch/sh/boards/mach-kfr2r09/lcd_wqvga.c         | 2 +-
>   arch/sh/boards/mach-kfr2r09/setup.c             | 2 +-
>   arch/sh/boards/mach-migor/lcd_qvga.c            | 2 +-
>   arch/sh/boards/mach-migor/setup.c               | 2 +-
>   arch/sh/boards/mach-rsk/devices-rsk7203.c       | 2 +-
>   arch/sh/boards/mach-rsk/devices-rsk7269.c       | 1 -
>   arch/sh/boards/mach-se/7724/setup.c             | 2 +-
>   arch/sh/include/mach-common/mach/magicpanelr2.h | 2 --
>   arch/sh/kernel/cpu/sh4a/setup-shx3.c            | 2 +-
>   15 files changed, 13 insertions(+), 16 deletions(-)

Reviewed-by: Philippe Mathieu-Daudé <philmd at oss.qualcomm.com>