[PATCH V3 3/8] Bluetooth: btnxpuart: Add M.2 Bluetooth device support using pwrseq

[Sherry Sun (OSS)]

From: Sherry Sun <sherry.sun at nxp.com>

Power supply to the M.2 Bluetooth device attached to the host using M.2
connector is controlled using the 'uart' pwrseq device. So add support for
getting the pwrseq device if the OF graph link is present. Once obtained,
pwrseq_power_on() is called to power up the M.2 Bluetooth card. The power
sequencer descriptor is obtained via devm_pwrseq_get(), so the power-off
and cleanup are handled automatically when the device is unbound.

Signed-off-by: Sherry Sun <sherry.sun at nxp.com>
Reviewed-by: Bartosz Golaszewski <bartosz.golaszewski at oss.qualcomm.com>
Reviewed-by: Frank Li <Frank.Li at nxp.com>
---
 drivers/bluetooth/btnxpuart.c | 14 ++++++++++++++
 1 file changed, 14 insertions(+)

diff --git a/drivers/bluetooth/btnxpuart.c b/drivers/bluetooth/btnxpuart.c
index e7036a48ce48..438ccaa2b56d 100644
--- a/drivers/bluetooth/btnxpuart.c
+++ b/drivers/bluetooth/btnxpuart.c
@@ -9,6 +9,8 @@
 
 #include <linux/serdev.h>
 #include <linux/of.h>
+#include <linux/of_graph.h>
+#include <linux/pwrseq/consumer.h>
 #include <linux/skbuff.h>
 #include <linux/unaligned.h>
 #include <linux/firmware.h>
@@ -1866,6 +1868,18 @@ static int nxp_serdev_probe(struct serdev_device *serdev)
 		return err;
 	}
 
+	if (of_graph_is_present(dev_of_node(&serdev->ctrl->dev))) {
+		struct pwrseq_desc *pwrseq;
+
+		pwrseq = devm_pwrseq_get(&serdev->ctrl->dev, "uart");
+		if (IS_ERR(pwrseq))
+			return PTR_ERR(pwrseq);
+
+		err = pwrseq_power_on(pwrseq);
+		if (err)
+			return err;
+	}
+
 	/* Initialize and register HCI device */
 	hdev = hci_alloc_dev();
 	if (!hdev) {
-- 
2.50.1