[PATCH 4/7] net: stmmac: dwmac-rk: Enable refout clock for RGMII

[Andrew Lunn]

On Wed, Jun 24, 2026 at 04:44:41PM +0800, Yanan He wrote:
> Some Rockchip GMAC integrations use clk_mac_refout as an external PHY
> reference clock even when the MAC is configured for RGMII.
> 
> RV1126 boards can route CLK_GMAC_ETHERNET_OUT to the external PHY as a
> 25 MHz reference clock. If the driver does not acquire and enable this
> clock in RGMII mode, the common clock framework may disable it as unused
> and the PHY can lose its reference clock.
> 
> Enable the refout clock handling for RGMII in addition to RMII.
> 
> Signed-off-by: Yanan He <grumpycat921013 at gmail.com>
> ---
>  drivers/net/ethernet/stmicro/stmmac/dwmac-rk.c | 6 ++++--
>  1 file changed, 4 insertions(+), 2 deletions(-)
> 
> diff --git a/drivers/net/ethernet/stmicro/stmmac/dwmac-rk.c b/drivers/net/ethernet/stmicro/stmmac/dwmac-rk.c
> index 8d7042e68926..f6fdc0c5b475 100644
> --- a/drivers/net/ethernet/stmicro/stmmac/dwmac-rk.c
> +++ b/drivers/net/ethernet/stmicro/stmmac/dwmac-rk.c
> @@ -1112,7 +1112,8 @@ static int rk_gmac_clk_init(struct plat_stmmacenet_data *plat)
>  	bsp_priv->clk_enabled = false;
>  
>  	bsp_priv->num_clks = ARRAY_SIZE(rk_clocks);
> -	if (phy_iface == PHY_INTERFACE_MODE_RMII)
> +	if (phy_iface == PHY_INTERFACE_MODE_RMII ||
> +	    phy_iface == PHY_INTERFACE_MODE_RGMII)

Apart from Heiko commenting that this patch is completely wrong, there
are 4 RGMII modes, not one. You should of used
phy_interface_mode_is_rgmii().

    Andrew

---
pw-bot: cr