[PATCH v3 11/15] drm/tidss: oldi: Fix OLDI signal polarities

[Swamil Jain]

On 29-05-2026 14:15, Tomi Valkeinen wrote:
> OLDI has a few issues with how it handles the signal polarities:
> 
> - It always sets OLDI_DEPOL, which means DE active low
> - It sets DRM_BUS_FLAG_DE_HIGH in struct drm_bridge_timings, i.e.
>    reverse to the OLDI_DEPOL
> - It sets DRM_BUS_FLAG_SYNC_SAMPLE_NEGEDGE in struct drm_bridge_timings,
>    but the TRM says "The DSS interface is clocked on the rising edge of
>    OLDI_FWD_P_CLK pixel clock", which I read as "OLDI samples on rising
>    edge".
> - But the defined drm_bridge_timings is not actually used anywhere, even
>    if it is set to bridge->timings, so the bus flags are just ignored.
> 
> However, based on my testing, OLDI_DEPOL bit or the edge on which data
> and syncs are driven doesn't seem to affect the OLDI output. Possibly
> it's not as robust, but I did not see any effect with an oscilloscope.
> 
> However, the code is still quite broken, so let's fix it:
> - Remove drm_bridge_timings
> - Set the correct input_bus_cfg.flags in tidss_oldi_atomic_check()
> - Set OLDI_DEPOL based on the DE bus flag
> 
> Tested-by: Swamil Jain <s-jain1 at ti.com>
> Signed-off-by: Tomi Valkeinen <tomi.valkeinen at ideasonboard.com>
> ---

Reviewed-by: Swamil Jain <s-jain1 at ti.com>

>   drivers/gpu/drm/tidss/tidss_oldi.c | 38 ++++++++++++++++++++++++++++----------
>   1 file changed, 28 insertions(+), 10 deletions(-)
> 
> diff --git a/drivers/gpu/drm/tidss/tidss_oldi.c b/drivers/gpu/drm/tidss/tidss_oldi.c
> index 17c535bfa057..e925ddaa4fd6 100644
> --- a/drivers/gpu/drm/tidss/tidss_oldi.c
> +++ b/drivers/gpu/drm/tidss/tidss_oldi.c
> @@ -164,7 +164,8 @@ static void tidss_oldi_tx_power(struct tidss_oldi *oldi, bool enable)
>   	regmap_update_bits(oldi->io_ctrl, OLDI_PD_CTRL, mask, enable ? 0 : mask);
>   }
>   
> -static int tidss_oldi_config(struct tidss_oldi *oldi)
> +static int tidss_oldi_config(struct tidss_oldi *oldi,
> +			     struct drm_bridge_state *bridge_state)
>   {
>   	const struct oldi_bus_format *bus_fmt = NULL;
>   	u32 oldi_cfg = 0;
> @@ -183,7 +184,8 @@ static int tidss_oldi_config(struct tidss_oldi *oldi)
>   			 "OLDI%u: DSS port width %d not supported\n",
>   			 oldi->oldi_instance, bus_fmt->data_width);
>   
> -	oldi_cfg |= OLDI_DEPOL;
> +	if (bridge_state->input_bus_cfg.flags & DRM_BUS_FLAG_DE_LOW)
> +		oldi_cfg |= OLDI_DEPOL; /* 1 = active low */
>   
>   	oldi_cfg = (oldi_cfg & (~OLDI_MAP)) | (bus_fmt->oldi_mode_reg_val << 1);
>   
> @@ -220,6 +222,22 @@ static int tidss_oldi_config(struct tidss_oldi *oldi)
>   	return ret;
>   }
>   
> +static int tidss_oldi_atomic_check(struct drm_bridge *bridge,
> +				   struct drm_bridge_state *bridge_state,
> +				   struct drm_crtc_state *crtc_state,
> +				   struct drm_connector_state *conn_state)
> +{
> +	bridge_state->input_bus_cfg.flags &=
> +		~(DRM_BUS_FLAG_PIXDATA_SAMPLE_NEGEDGE |
> +		  DRM_BUS_FLAG_SYNC_SAMPLE_NEGEDGE);
> +
> +	bridge_state->input_bus_cfg.flags |=
> +		DRM_BUS_FLAG_PIXDATA_SAMPLE_POSEDGE |
> +		DRM_BUS_FLAG_SYNC_SAMPLE_POSEDGE;
> +
> +	return 0;
> +}
> +
>   static void tidss_oldi_atomic_pre_enable(struct drm_bridge *bridge,
>   					 struct drm_atomic_state *state)
>   {
> @@ -228,6 +246,7 @@ static void tidss_oldi_atomic_pre_enable(struct drm_bridge *bridge,
>   	struct drm_connector_state *conn_state;
>   	struct drm_crtc_state *crtc_state;
>   	struct drm_display_mode *mode;
> +	struct drm_bridge_state *bridge_state;
>   
>   	if (oldi->link_type == OLDI_MODE_SECONDARY_CLONE_SINGLE_LINK)
>   		return;
> @@ -245,10 +264,14 @@ static void tidss_oldi_atomic_pre_enable(struct drm_bridge *bridge,
>   	if (WARN_ON(!crtc_state))
>   		return;
>   
> +	bridge_state = drm_atomic_get_new_bridge_state(state, bridge);
> +	if (WARN_ON(!bridge_state))
> +		return;
> +
>   	mode = &crtc_state->adjusted_mode;
>   
>   	/* Configure the OLDI params*/
> -	tidss_oldi_config(oldi);
> +	tidss_oldi_config(oldi, bridge_state);
>   
>   	/* Set the OLDI serial clock (7 times the pixel clock) */
>   	tidss_oldi_set_serial_clk(oldi, mode->clock * 7 * 1000);
> @@ -329,7 +352,8 @@ tidss_oldi_mode_valid(struct drm_bridge *bridge,
>   }
>   
>   static const struct drm_bridge_funcs tidss_oldi_bridge_funcs = {
> -	.attach	= tidss_oldi_bridge_attach,
> +	.attach = tidss_oldi_bridge_attach,
> +	.atomic_check = tidss_oldi_atomic_check,
>   	.atomic_pre_enable = tidss_oldi_atomic_pre_enable,
>   	.atomic_post_disable = tidss_oldi_atomic_post_disable,
>   	.atomic_get_input_bus_fmts = tidss_oldi_atomic_get_input_bus_fmts,
> @@ -440,11 +464,6 @@ static int get_parent_dss_vp(struct device_node *oldi_tx, u32 *parent_vp)
>   	return -ENODEV;
>   }
>   
> -static const struct drm_bridge_timings default_tidss_oldi_timings = {
> -	.input_bus_flags = DRM_BUS_FLAG_SYNC_SAMPLE_NEGEDGE
> -			 | DRM_BUS_FLAG_DE_HIGH,
> -};
> -
>   void tidss_oldi_deinit(struct tidss_device *tidss)
>   {
>   	for (int i = 0; i < tidss->num_oldis; i++) {
> @@ -598,7 +617,6 @@ int tidss_oldi_init(struct tidss_device *tidss)
>   		/* Register the bridge. */
>   		oldi->bridge.of_node = child;
>   		oldi->bridge.driver_private = oldi;
> -		oldi->bridge.timings = &default_tidss_oldi_timings;
>   
>   		tidss->oldis[tidss->num_oldis++] = oldi;
>   		tidss->is_ext_vp_clk[oldi->parent_vp] = true;
>