[PATCH 5/7] i2c: nomadik: change print level for fault messages to debug

[Dmitry Guzman]

i2c-nomadik driver prints error message on every faulted message. This
is not a good practice, because in I2C a fault not always is an error,
sometimes it is the expected result. For example, scanning bus with
`i2cdetects` prints over 100 messages in dmesg (two messages per each
target address).

To avoid excessive prints in the log, change the print level from err to
debug.

Signed-off-by: Dmitry Guzman <Dmitry.Guzman at mobileye.com>
---
 drivers/i2c/busses/i2c-nomadik.c | 4 ++--
 1 file changed, 2 insertions(+), 2 deletions(-)

diff --git a/drivers/i2c/busses/i2c-nomadik.c b/drivers/i2c/busses/i2c-nomadik.c
index e19ace904e79cd2d83171d9f38fc103a6c5e023b..7d93fb3876dc1324003dd19884e3fd5cbba9cfbb 100644
--- a/drivers/i2c/busses/i2c-nomadik.c
+++ b/drivers/i2c/busses/i2c-nomadik.c
@@ -627,7 +627,7 @@ static int write_i2c(struct nmk_i2c_dev *priv, u16 flags)
 
 	if (!xfer_done) {
 		/* Controller timed out */
-		dev_err(&priv->adev->dev, "write to slave 0x%x timed out\n",
+		dev_dbg(&priv->adev->dev, "write to slave 0x%x timed out\n",
 			priv->cli.slave_adr);
 		status = -ETIMEDOUT;
 	}
@@ -661,7 +661,7 @@ static int nmk_i2c_xfer_one(struct nmk_i2c_dev *priv, u16 flags)
 		i2c_sr = readl(priv->virtbase + I2C_SR);
 		if (FIELD_GET(I2C_SR_STATUS, i2c_sr) == I2C_ABORT) {
 			cause = FIELD_GET(I2C_SR_CAUSE, i2c_sr);
-			dev_err(&priv->adev->dev, "%s\n",
+			dev_dbg(&priv->adev->dev, "%s\n",
 				cause >= ARRAY_SIZE(abort_causes) ?
 				"unknown reason" :
 				abort_causes[cause]);

-- 
2.43.0