[PATCH v3 2/2] iio: adc: add Axiado SARADC driver

[Joshua Crofts]

On Mon, 22 Jun 2026 00:47:28 -0700
Petar Stepanovic <pstepanovic at axiado.com> wrote:

> Add support for the SARADC controller found on Axiado AX3000 and
> AX3005 SoCs.
> 
> The driver supports single-shot voltage reads through the IIO
> subsystem. The number of available input channels is selected from
> the SoC match data, allowing AX3000 and AX3005 variants to use the
> same driver.
> 
> Signed-off-by: Petar Stepanovic <pstepanovic at axiado.com>
> ---
> +	info->clk_rate = clk_get_rate(info->clk);
> +	if (!info->clk_rate)
> +		return dev_err_probe(dev, -EINVAL, "invalid clock rate\n");
> +
> +	ret = devm_regulator_get_enable_read_voltage(dev, "vref");
> +	if (ret < 0)
> +		return dev_err_probe(dev, info->vref_uV,
> +				     "failed to get vref voltage\n");

Sashiko raised an issue that I've missed on previous reads - why
are you using info->vref_uV in dev_err_probe()? The info struct
is not zeroed out on initialization, which means that dev_err_probe
will return a different value each time when read_voltage() fails.
It was designed to accept the retval from whatever function we're
checking. 

-- 
Kind regards

CJD