[PATCH 2/2] ARM: dts: aspeed: sanmiguel: add current-range property for PDB HSC

[Mike Hsieh]

Configure the ti,current-range property for the four TI LM5066i
hot-swap controllers on PDB board.

This defines the hardware current limit operating mode (low/high)
for each sensor to match the physical board design.

Specific configurations:
- HSC1 (0x11): low
- HSC2 (0x13): high
- HSC3 (0x15): high
- HSC4 (0x17): low

Signed-off-by: Mike Hsieh <mike.quanta.115 at gmail.com>
---
 arch/arm/boot/dts/aspeed/aspeed-bmc-facebook-sanmiguel.dts | 4 ++++
 1 file changed, 4 insertions(+)

diff --git a/arch/arm/boot/dts/aspeed/aspeed-bmc-facebook-sanmiguel.dts b/arch/arm/boot/dts/aspeed/aspeed-bmc-facebook-sanmiguel.dts
index 3faac0925a79..e518e3fc1c97 100644
--- a/arch/arm/boot/dts/aspeed/aspeed-bmc-facebook-sanmiguel.dts
+++ b/arch/arm/boot/dts/aspeed/aspeed-bmc-facebook-sanmiguel.dts
@@ -451,6 +451,7 @@ pdb_ti_hsc1: power-monitor at 11 {
 		compatible = "ti,lm5066i";
 		reg = <0x11>;
 		shunt-resistor-micro-ohms = <1000>;
+		ti,current-range = "low";
 	};
 
 	pdb_mps_hsc2: power-monitor at 12 {
@@ -462,6 +463,7 @@ pdb_ti_hsc2: power-monitor at 13 {
 		compatible = "ti,lm5066i";
 		reg = <0x13>;
 		shunt-resistor-micro-ohms = <321>;
+		ti,current-range = "high";
 	};
 
 	pdb_mps_hsc3: power-monitor at 14 {
@@ -473,6 +475,7 @@ pdb_ti_hsc3: power-monitor at 15 {
 		compatible = "ti,lm5066i";
 		reg = <0x15>;
 		shunt-resistor-micro-ohms = <321>;
+		ti,current-range = "high";
 	};
 
 	pdb_mps_hsc4: power-monitor at 16 {
@@ -484,6 +487,7 @@ pdb_ti_hsc4: power-monitor at 17 {
 		compatible = "ti,lm5066i";
 		reg = <0x17>;
 		shunt-resistor-micro-ohms = <500>;
+		ti,current-range = "low";
 	};
 
 	pdb_ioexp_20: gpio at 20 {

-- 
2.53.0