[PATCH RFC 8/9] arm64: dts: qcom: shikra-cqs-evk: Enable ethernet0

[Mohd Ayaan Anwar]

On Tue, Jun 16, 2026 at 11:50:26AM +0200, Konrad Dybcio wrote:
> On 6/11/26 8:37 PM, Mohd Ayaan Anwar wrote:
> 
> > +&tlmm {
> > +	ethernet0_defaults: ethernet0-defaults-state {
> 
> s/defaults/default
> 
> Please move this definition to shikra.dtsi
> 

The CQM and CQS variants have identical GPIO mapping but the IQS is
different. So should I keep this in shikra.dtsi and overwrite for IQS in
shikra-iqs-evk.dts?


> > +
> > +	emac0_phy_en_hog: emac0-phy-en-hog {
> > +		gpio-hog;
> > +		gpios = <149 GPIO_ACTIVE_HIGH>;
> > +		output-high;
> > +		line-name = "emac0-phy-en";
> > +	};
> 
> This looks like a hack - what does this pin actually do?
> 

The power supply to both PHYs on Shikra is gated by a GPIO pin. I am
unsure whether they should be modelled as a fixed, enable-on-boot
regulator or just like this. They need to be powered on early so that
MDIO can detect them.

Thank you for the review. I will fix the stylistic issues in v2.

	Ayaan