[PATCH v3 0/3] perf: marvell: LLC-TAD PMU MPAM filtering support

[Geetha sowjanya]

This series extends the Marvell LLC-TAD performance driver used on CN10K
and CN20K systems.

Patch 1 adds optional MPAM partition-id filtering for the subset of TAD
events that support it, exposes partid / partid_en in the PMU format string,
and keeps the reduced Odyssey event surface without advertising partid where
it does not apply.  It also fixes probe resource handling (no in-place
mutation of platform_get_resource() bounds, validate MMIO window vs
tad-cnt), orders perf registration vs hotplug with unwind, and aligns the
filter-enable bit in config1 with the sysfs format (bit 9).

Patch 2 introduces CN20K LLC-TAD support: non-standard PFC/PRF offsets,
additional programmable events with visibility checks so CN10K does not
advertise V3-only events, CN20K-specific MPAM encoding for the V3 profile,
local64_set(prev_count) on counter start, and device discovery via OF and
ACPI.

Patch 3 extends the DeviceTree binding for marvell,cn20k-tad-pmu.

Changes since v2
----------------
- Validate the eventId using an appropriate mask to ensure it is restricted to 8 bits.

Changes since v1
----------------
- config1: use bit 9 for MPAM filter enable consistently with partid_en in
  the PMU format; allow only bits 0..9 in event_init on CN10K/CN20K paths.
- Reject reserved bits in attr.config and use the same 8-bit event index in
  start_counter as in event_init so MPAM validation cannot be bypassed.
- Hide V3-only sysfs events on V1.
- Reset prev_count when starting counters after clearing hardware.
- DT binding: explain non-fallback compatibles for CN10K vs CN20K.

Tanmay Jagdale (1):
  perf: marvell: Add MPAM partid filtering to CN10K TAD PMU

Geetha sowjanya (2):
  perf: marvell: Add CN20K LLC-TAD PMU support
  dt-bindings: perf: marvell: Extend CN10K TAD PMU binding for CN20K

Signed-off-by: Geetha sowjanya <gakula at marvell.com>

-- 
2.25.1