[PATCH v8 04/12] iommu/tegra241-cmdqv: Restore PROD and CONS after resume

[Mostafa Saleh]

On Mon, Jun 01, 2026 at 09:59:01PM +0000, Pranjal Shrivastava wrote:
> From: Ashish Mhetre <amhetre at nvidia.com>
> 
> PROD and CONS indices for vcmdqs are getting set to 0 after resume.
> Because of this the vcmdq is not consuming commands after resume.
> Fix this by restoring PROD and CONS indices after resume from
> saved pointers.

What commands are exisiting at resume? Won't
tegra241_cmdqv_drain_vintf0_lvcmdqs() drain the queues and make the
PROD and CONS equal each other anyway?

Thanks,
Mostafa

> 
> Reviewed-by: Nicolin Chen <nicolinc at nvidia.com>
> Signed-off-by: Ashish Mhetre <amhetre at nvidia.com>
> Signed-off-by: Pranjal Shrivastava <praan at google.com>
> ---
>  drivers/iommu/arm/arm-smmu-v3/tegra241-cmdqv.c | 2 ++
>  1 file changed, 2 insertions(+)
> 
> diff --git a/drivers/iommu/arm/arm-smmu-v3/tegra241-cmdqv.c b/drivers/iommu/arm/arm-smmu-v3/tegra241-cmdqv.c
> index cb1e75e4ee91..866cae7b73e5 100644
> --- a/drivers/iommu/arm/arm-smmu-v3/tegra241-cmdqv.c
> +++ b/drivers/iommu/arm/arm-smmu-v3/tegra241-cmdqv.c
> @@ -511,6 +511,8 @@ static int tegra241_vcmdq_hw_init(struct tegra241_vcmdq *vcmdq)
>  
>  	/* Configure and enable VCMDQ */
>  	writeq_relaxed(vcmdq->cmdq.q.q_base, REG_VCMDQ_PAGE1(vcmdq, BASE));
> +	writel_relaxed(vcmdq->cmdq.q.llq.prod, REG_VCMDQ_PAGE0(vcmdq, PROD));
> +	writel_relaxed(vcmdq->cmdq.q.llq.cons, REG_VCMDQ_PAGE0(vcmdq, CONS));
>  
>  	ret = vcmdq_write_config(vcmdq, VCMDQ_EN);
>  	if (ret) {
> -- 
> 2.54.0.1013.g208068f2d8-goog
> 
>