[PATCH] dmaengine: xilinx: Treat "xlnx,flush-fsync" as a flag

[Pandey, Radhey Shyam]

> The Xilinx DMA binding documents "xlnx,flush-fsync" as a boolean flag.
> The driver read it as an integer cell and warned when it was absent,
> which does not match the documented property encoding.

The original .txt binding (before schema conversion) was not a boolean:
xlnx,flush-fsync: Tells which channel to Flush on Frame sync.
It takes following values:
{1}, flush both channels
{2}, flush mm2s channel
{3}, flush s2mm channel

xilinx_dma_device struct stored it in u32 flush_on_fsync. However yaml
conversion silently changed this to bool which was incorrect. I think
we should change in YAML to make xlnx,flush-fsync as u32?

> 
> Use the boolean helper so the driver follows the binding. Leave
> "xlnx,irq-delay" as an 8-bit property read because the hardware field
> is 8 bits wide.
We can skip about irq-delay mention here.

Thanks,
Radhey>
> Assisted-by: Codex:gpt-5-5
> Signed-off-by: Rob Herring (Arm) <robh at kernel.org>
> ---
>   drivers/dma/xilinx/xilinx_dma.c | 7 ++-----
>   1 file changed, 2 insertions(+), 5 deletions(-)
> 
> diff --git a/drivers/dma/xilinx/xilinx_dma.c b/drivers/dma/xilinx/xilinx_dma.c
> index 404235c17353..cbb23fd6e096 100644
> --- a/drivers/dma/xilinx/xilinx_dma.c
> +++ b/drivers/dma/xilinx/xilinx_dma.c
> @@ -3262,11 +3262,8 @@ static int xilinx_dma_probe(struct platform_device *pdev)
>   			goto disable_clks;
>   		}
>   
> -		err = of_property_read_u32(node, "xlnx,flush-fsync",
> -					   &xdev->flush_on_fsync);
> -		if (err < 0)
> -			dev_warn(xdev->dev,
> -				 "missing xlnx,flush-fsync property\n");
> +		xdev->flush_on_fsync =
> +			of_property_read_bool(node, "xlnx,flush-fsync");
>   	}
>   
>   	err = of_property_read_u32(node, "xlnx,addrwidth", &addr_width);